Manual Severin KA 5994 (page 14 of 84) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

712156

Zoom out

Zoom in

1/84

142 x 208 mm

Change factory settings

∙ Theunithasvariousfunctionswhichmaybemodiedas

follows:

∙ Turn the unit on and wait until the cup symbols are

permanently lit.

∙ Press the button for 10 seconds to enter the Change

factory settingsmode.Allthreebuttonsashalternately.

∙ Modify the default factory settings as described further

below.

∙ If no input is registered for about 15 seconds, the unit

returns to ‘Ready’ mode.

∙ To return the various functions (water hardness,

automatic switch-off, temperature, amount) back

to their factory settings, press the buttons and

simultaneously, keeping them pressed for three

seconds. The , and buttonsstartashing

and two beep signals are heard. The appliance switches

off.

Adjusting the level of water hardness

∙ Theunitgivesyouadescalingnotication.Depending

on the water quality (lime content), the button will

ashafter600,500(factorysetting)or400cupcycles.

∙ To ensure proper functioning of the descaling

notication,thelevelofwaterhardnessinyourarea

must be set.

∙ The level of water hardness can be set for soft, normal

or hard water.

∙ Enter the Change factory settings mode (see Change

factory settings).

∙ Press brieytoenterthe‘waterhardness’mode.

∙ Press one of the following buttons for 3 seconds to set

the required water hardness:

∙ : soft water (< 8.4 °dH)

∙ : medium hard water (8.4 – 14 °dH)

∙ : hard water (> 14 °dH / 2.5 mmol/l)

∙ After 3 seconds, the buttonashes3timesto

conrmthenewsetting.Theunitreturnsto‘Ready’

mode.

Automatic switch-off

∙ This appliance comes with an automatic switch-off

feature.

∙ The unit automatically switches off after 25 minutes of

non-use.

∙ The duration until automatic switch-off can set at 9

minutes, 25 minutes (factory setting) or 3 hours:

∙ Enter the Change factory settings mode (see Change

factory settings).

∙ Press brieytoentertheAutomatic switch-off

mode.

∙ Press one of the following buttons for 3 seconds to set

the desired auto switch-off time:

∙ : 9 minutes

∙ : 25 minutes

∙ : 3 hours

∙ After 3 seconds, the

buttonashes3timesto

conrmthenewsetting.Theunitreturnsto‘Ready’

mode.

Changing the espresso temperature

∙ The temperature of the espresso can be adjusted to low,

medium (factory setting) and high.

∙ Adjust the temperature as follows:

∙ Enter the Change factory settings mode (see Change

factory settings).

∙ Press brieytoentertheChanging the espresso

temperature mode.

∙ Press one of the following buttons for 3 seconds to set

the desired temperature:

∙

: low

∙ : medium

∙

: high

∙ After 3 seconds, the

buttonashes3timesto

conrmthenewsetting.Theunitreturnsto‘Ready’

mode.

Changing the espresso amount

∙ The amount of espresso per cup can be adjusted

individually.

∙ Proceed as described in Making espresso, but keep the

or pressed, until the desired espresso amount

has been drawn.

∙ This amount setting is now saved for future cups. The

amount of espresso must be between 15 and 220 ml.

Any other quantities cannot be saved.

∙ The default factory setting is 20 ml/cup.

Cleaning and care

∙ Remove the plug from the wall socket and wait until the

appliance has cooled down.

∙ To avoid the risk of electric shock, do not clean the

appliance with liquids or immerse it.

∙ Do not use abrasives or harsh cleaning solutions.

∙ Allow the panarello to cool down after each use,

then remove and clean it with hot soapy water. The

small aperture on the centre of the panarello must be

unobstructed at all times. If necessary, remove any

blockageusinganeneedle.

∙ Wipe the outside of the steam tube with a damp cloth.

∙ Allowthesieveholdertocooldownsufcientlybefore

tapping its side against a vertical surface to loosen the

grounds before emptying it.

∙ Theindentationsonthelterholderfacilitateremoving

theltersieve;usethengerstopullthesieveoutfrom

above.

∙ Thelterholder,lterinsertsanddriptraymaybe

cleaned in warm water using a mild detergent; do not

clean these parts in a dish-washer.

∙ Remove the water container and pour out any remaining

water. Clean the container with soapy water and dry

thoroughly.

∙ The exterior housing may be wiped with a damp, lint-

free cloth.

The steam wand for making frothy milk is not working Submitted on 2-2-2021 at 20:07
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KA 5994 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KA 5994 Manual

Product: