712156
13
Zoom out
Zoom in
Previous page
1/84
Next page
13
142 x 208 mm
Before using for the rst time
Unpack the appliance completely and remove all
packaging materials. But do not remove the safety
sticker.
Clean all detachable parts as described in the section
Cleaning and care.
Fit the panarello to the steam tube.
Fill the container with water (see Making espresso).
Adjust the water hardness as described in Adjusting the
level of water hardness.
Beforemakingespressoforthersttime,ushthe
system by drawing 2-3 large cups of water as described
in Making espresso, but without using any coffee.
During this process, use the panarello repeatedly as
described in Dispensing hot water.
This should also be done if the appliance has not been
used for an extended period of time.
Before switching on, ensure that the rotary control is set
to .Otherwiseallbuttonswillashandtheunitcannot
be used.
Preparing beverages
Pre-heating cups
For optimum taste enjoyment we recommend to pre-heat
the cups. Rinse the cups with hot water or place them on
the cup-warming top.
Making espresso
Removethewatercontainer,openthelidandllwith
fresh water, observing the min/max marking.
Ensure that the rotary control is set to .
Using espresso powder:
Fitthelterinsertforoneortwocupsintothelter
holder.
Loadthelterinsertwiththedesiredamountofespresso
coffee. We recommend 7.5 g per cup.
Use the tamper surface on the measuring scoop to
pushdowntheespressocoffeeevenlyandrmlywitha
pressure of around 15 kg.
Removeanyexcesscoffeefromtherimofthelter
holder.
Using ESE pods:
FitthelterinsertforESEpodsintothelterholder.
Insert a pod.
Fitthelterholderwiththehandlefacingleft to
theboileroutlet.Securethelterholderbyturningthe
handle to the right, locking it underneath the symbol.
Place one or two cup(s) onto the drip tray underneath
the outlet opening.
Press to turn the unit on. The cup symbols start
ashingslowlywhiletheunitispre-heating.
Once the cup symbols are permanently lit, the brewing
process can be started by pressing or button.
Once brewing is complete, remove the cup(s) and
switch the unit off.
Allowthelterholdertocooldown,thenremoveand
clean it as described in Cleaning and care.
To avoid spilling, always empty the drip tray in good
time,observingtheredoatindicator.
Hint: If the appliance has been used for frothing or
hot water, it must be allowed to cool down before
making espresso. The
and
buttons are
ashingrapidlytoshowthattheunitistoohot.
To accelerate cooling, you can release water from
the panarello. Place a suitable container underneath
the panarello and set the rotary control to for
around 2 seconds. The unit is ready for use when the
and buttons are permanently lit.
Making cappuccino
First prepare the espresso as described in Making
espresso.
Fill a suitable heat-resistant jug with about 100 ml of
fresh, cold milk from the fridge.
To prevent the milk from spilling over during the frothing
process, the jug should be only half full.
Press .Thebuttonasheswhiletheunitispre-
heating.
Once the button shows a steady light, place the milk
jug underneath the panarello so that the lower of the
panarello is just submerged in the milk.
Turn the rotary control to the position. The
panarello is now open.
Turn the jug with a circular motion for around 40-45
seconds.
Oncethemilkissufcientlyfrothy,turnthecontrolback
to the espresso symbol ( ).
Use a spoon to spread the milk froth over the espresso.
The proper ratio should be 1/3 espresso, 1/3 hot milk
and 1/3 milk froth.
Dispensing hot water
Removethewatercontainer,openthelidandllwith
fresh water, observing the min/max marking.
Press to turn the unit on.
Once the and buttons shows a steady light,
place a suitable container underneath the panarello.
Set the rotary control to .
Once hot water has been drawn, set the rotary control
back to .
13


Need help? Post your question in this forum.

Forumrules
1

Forum

severin-ka-5994

Reset search

  • The steam wand for making frothy milk is not working Submitted on 2-2-2021 at 20:07

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KA 5994 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KA 5994 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info