Manual Severin KA 4460 (page 13 of 84) (English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish)

602817

Zoom out

Zoom in

1/84

Before using for the ﬁ rst time

Before making coffee for the ﬁ rst time,

let the appliance go through two or three

ﬁ ltration cycles using the indicated maximum

amount of cold water, but without using

ground coffee. This should also be done

if the appliance has not been used for an

extended period of time, and after descaling.

General information

∙ A measuring scale on the water container

and on the glass carafe facilitates ﬁ lling

the container with the correct amount

of clean water. With a dual-scale, the

left scale is used for regular-sized cups

of approx.125 ml, while the right scale is

used for smaller cups. Make sure that the

indicated maximum amount of water is not

exceeded.

∙ If several consecutive brewing cycles

are required, switch off the coffee maker

after each cycle and let the appliance cool

down for approx. 5 minutes.

∙ Important note: When replacing a

re-ﬁ lled water container shortly after

a brewing cycle has only just been

completed, there is a danger of scalding

from hot water or steam escaping through

the water outlet.

Making coffee

∙ Filling with water:

Take out the water container, open the lid,

ﬁ ll the container with the desired quantity of

cold water, close the lid again and replace

the container in the appliance. The container

is hooked in at the top, and must be sitting

ﬂ ush against the appliance.

∙ Inserting the paper ﬁ lter:

Open the swing-out ﬁ lter sideways and insert

a size-4 paper ﬁ lter into the ﬁ lter holder, ﬁ rst

folding down the perforated sides of the ﬁ lter.

∙ Filling with ground coffee:

For each regular-sized cup (125 ml), a

measure of about 6 g (= 1½ - 2 teaspoons)

of medium or ﬁ nely ground coffee will

be required. Close the swing-out ﬁ lter

afterwards.

∙ Preparing the glass carafe:

Fit the lid onto the carafe, and then place

the carafe into the appliance. If correctly

inserted, the lid will disable the drip-stop

mechanism in the ﬁ lter holder during the

brewing cycle.

∙ Starting the brewing cycle manually:

Press the On/Off button once to turn on the

coffee maker. The blue indicator light

comes on.

∙ Starting the brewing cycle at a later

pre-determined time:

Press the AUTO button. The blue AUTO

indicator light comes on and the current

and pre-programmed starting time appear

alternately in the display. The coffee maker

will automatically switch on at the chosen

time.

To check or adjust the pre-programmed

starting time, do not press the AUTO button

at this point; but instead press the PROG

button twice and then change the time, as

described in the Timer section if necessary.

∙ Removing the glass carafe:

Wait until all the water has passed through

the ﬁ lter before the carafe is removed from

the appliance.

∙ Switching off the coffee maker:

The coffee may be kept warm inside the

carafe by leaving it standing on the hot-plate.

The plate stays warm for about 40 minutes,

but can also be switched off earlier by

pressing the On/Off button. The blue main

indicator lamp then goes out.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KA 4460 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,98 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KA 4460 Manual

Product: