Manual Sentiotec IS2 (page 21 of 100) (English, German, Dutch, French, Italian, Swedish)

753105

Zoom out

Zoom in

1/100

5 Mounting of the control unit

Caution - damage to the device: Do not use a cordless screwdriver to mount the control unit.

5.1 Removal of the front lid

In order to mount the control unit to the wall, the front

cover of the control unit must be removed. To this end,

use a ﬂ at screwdriver with a breadth of approx. 3mm.

• Guide the screwdriver into the intended opening on

the underside of the control

• The lid is held on by a snap-on hook.

• Press this carefully inwards until the lid becomes detached.

• Now remove the lid from the control unit.

After the operating element is attached to the wall,

the lid must be replaced.

• First of all, mount the lid on its upper edge into the control unit housing.

• Now press the underside against the housing until the lid locks into place again.

Fig 6 Remove lid

5.2 Surface mounting

Use the long screws contained in the scope of supply to mount the

control unit. Do not use a larger diameter under any circumstances.

This can cause irreparable damage to the housing.

When inserting the screws, ensure no damage

is caused to any cables installed in the wall.

This can cause serious injury to people and

serious damage to property.

Fig. 7 Surface mounting

WE DO IT FIRST.

Instructions for installation and use – only for experts P. 7/14

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sentiotec IS2 in the language / languages: English, German, Dutch, French, Italian, Swedish as an attachment in your email.

The manual is 4,21 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sentiotec IS2 Manual

Product: