753055
37
Zoom out
Zoom in
Previous page
1/56
Next page
EN
Installation instructions, for professionals only p. 9/27
4. Installation and connection
ATTENTION!
Damage to the unit
The sauna control unit is protected against jets of water, however direct contact
with water could still damage the unit.
Install the sauna control unit in a dry place at which a maximum humidity of
95 % is not exceeded.
Observe the following points when installing and connecting the sauna control unit:
The sauna control unit must be installed outside the sauna room at a height
of approx. 1.70 m or in accordance with the recommendation issued by the
sauna manufacturer. The ambient temperature must be within a range span-
ning -10 °C to +40 °C.
There must be a xed connection for the electrical power supply.
The heater sensor wires must be laid separately from the other mains wires
and control wires. Wires with only one layer of insulation must be protected
by using a pipe (double insulation).
An all-pole disconnecting device with full cut-o󰀨 compliant with overvoltage
category III must be tted on-site.
The sensor may only be connected using the sensor wires provided with the
unit, which are heat-resistant up to 150 °C.
The heater sensor must be installed in the sauna cabin above the middle of
the sauna heater. A clearance of approx. 15 cm to the roof of the sauna room
must be maintained.
The heater sensor must be attached in a way that it is not affected by
a ow of air.
ATTENTION!
Damage to the unit
The sauna control unit may only be used for operating and controlling 3 heating
circuits with a maximum heating capacity of 5 kW per heating circuit.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sentiotec A2-15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sentiotec A2-15 in the language / languages: English, German as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info