759443
8
Zoom out
Zoom in
Previous page
1/14
Next page
EN-8
EN
Vacuum Cleaner
SVC 610RD / SVC 611BL
Copyright © 2016, Fast ČR, a.s. Revision 02/2016
USING THE VACUUM CLEANER
Connecting the vacuum cleaner to the power grid
Wind out the required length of the power cord by pulling on the power plug. Insert the power plug
into a power socket.
Caution:
The yellow marking on the power cord warns you that the power cord is close to its end. Do not
pull the cord further than the red marking.
Adjusting the floor nozzle Aqd according to the floor surface.
You may set the floor nozzle according to the floor surface by adjusting the inlet flap:
If you want to vacuum carpets, move the flap to retract the bristles.
If you want to vacuum hard and smooth surfaces, move the flap to extend the bristles.
Turning the vacuum cleaner on and off
To switch the vacuum cleaner on, press the START/STOP button A1. To turn off the vacuum cleaner,
press the button again.
Suction power control dial A3
Suction power may be adjusted by turning the dial on the body of the appliance or adjusted in a smaller
range using the sliding flap on the hose handle A0.
Tips
Use the maximum suction strength when vacuuming carpets or floors with a hard surface.
Use the reduced strength when vacuuming upholstery, window curtains, etc.
If the holder A9 of the hose Aqh becomes blocked when vacuuming, disconnect it from the
telescopic tube Aqa and also disconnect the hose Aqh from the vacuum cleaner body. Then
place the holder A9 inside the hose socket on the vacuum cleaner body and vacuum the
stuck dirt out.
Temporary interruption of the vacuuming process
If you want to temporarily stop the vacuuming process, place the telescopic tube Aqa using the notches
on the floor nozzle Aqd into one of the parking positions - at the back or bottom of the vacuum cleaner.
Attention:
Do not move the vacuum cleaner from place to place if the hose is in the parked position! The
stopper on the floor nozzle could brake off.
Using the accessories
D
3
1
2
1 Slot nozzle for vacuuming in hard to reach
places (e.g. windows, corners, book shelves,
areas between mattresses, upholstery, etc.)
2 Upholstery nozzle
3 Brush nozzle
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SVC 610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SVC 610 in the language / languages: English as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info