758818
8
Zoom out
Zoom in
Previous page
1/10
Next page
EN-8
EN
Slow Juicer
SSJ 5050SS / SSJ 5051RD
Copyright © 2016, Fast ČR, a.s. 04/2016
Do not use the juicer for processing frozen or excessively hard ingredients, e.g. sugar cane.
Place the ingredients into the feed tube A2 gradually and push through gently with mild pressure.
Do not overfill the feed tube A2 and do not push the ingredients in too quickly and with excessive
pressure. The process of separating the juice from the pulp occurs gradually and will not be sped
up by pushing ingredients in quickly.
To prevent freshly pressed apple juice from turning brown, you can add a little lemon juice.
To prevent losing valuable minerals, we recommended consuming the juice immediately after it is
pressed.
DISASSEMBLING THE JUICER
1. Before disassembling the juicer, make sure that it is turned off and disconnected from the power
socket. Make sure that all parts that move during operation have stopped moving.
2. Remove the juice jug A0 and the pulp container A9. Take the pusher A1 out of the feed tube
A2.
3. Release both the locking arms Aqa by lifting them upwards and tilting them out towards the juice
collector A6.
4. Rotate the feed tube A2 anticlockwise and take it off the juice collector A6.
5. Take the juice collector A6 with the strainer A4 and the screw shaft A3 located inside off the
base unit Aqd by lifting it upwards.
Note:
It will be easier to take the juice collector A6 off the base unit Aqd when you clean out the pulp
remains after juicing, as described in point 5 in chapter Using the juicer.
6. Over a sink, take the screw shaft A3 and strainer A4 out of the juice collector A6.
CLEANING AND MAINTENANCE
Clean out the juicer after every use. Before cleaning it, make sure that the juicer is turned off,
disconnected from the power socket and properly disassembled.
Remove juice and pulp residues from the juice jug A0 and the pulp container A9. Thoroughly
wash both containers A0 and A9, the pusher A1, the feed tube with hopper and lid A2 and the
screw shaft A3 using warm water with kitchen detergent. Then rinse them under clean running
water and thoroughly wipe dry with a fine wiping cloth.
Thoroughly wash the strainer A4 and the juice collector A6 under warm running water using
kitchen detergent and a fine nylon brush. If you are unsuccessful in cleaning out the small holes
in the strainer A4, soak it first in warm water containing lemon juice. Then to finish off, rinse the
strainer A4 and the juice collector A6 under clean running water and thoroughly wipe dry with
a fine wiping cloth.
Note:
We recommend that all accessories are washed immediately after use. Dried on juice and pulp
residues are far more difficult to remove and may clog the holes in the strainer A4 and thereby
reduce juicing efficiency.
All removable parts can also be safely washed in a dishwasher.
For cleaning the base unit Aqd, use a cloth lightly dipped in a weak solution of water and neutral
kitchen detergent. Then wipe the surface of the base unit Aqd with a clean dampened cloth and
dry thoroughly. Never submerge the base unit Aqd in water or rinse it under running water.
Do not use abrasive cleaning products, solvents, thinners, etc. Otherwise the surface may be
damaged.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SSJ 5051 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SSJ 5051 in the language / languages: English as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info