759177

Sencor SDH 1020 Manual

8
Zoom out
Zoom in
Previous page
1/11
Next page
- 8 - 12/2020
Copyright © 2020, Fast ČR, a.s.
EN Dehumidifier
User'smanual
■ Prior to using this appliance, please read the user‘smanual thoroughly, even in cases,
when one has already familiarised themselves with previous use of similar types of
appliances. Only use the appliance in the manner described in this user’smanual.
Keep this user‘smanual in asafe place where it can be easily retrieved for future use.
■ We recommend saving the original cardboard box, packaging material, purchase
receipt and responsibility statement of the vendor or warranty card for at least the
duration of the legal liability for unsatisfactory performance or quality. In the event
of transportation, we recommend that you pack the appliance in the original box
from the manufacturer.
DESCRIPTION OF THE APPLIANCE
A1 Control panel
A2 Air outlet grille
A3 Condensation unit (behind the front
cover)
A4 Condensate level gauge
A5 Indents for easy removal of the tank
(on both sides)
A6 Condensate tank
A7 Handle
A8 Air inlet grille with filter
A9 Drain hose connection outlet
A10 Power cord strap (used only for
storage)
A11 Power plug storage compartment
A12 Power cord
DESCRIPTION OF THE CONTROL PANEL
B1 Continuous dehumidification
indicator light
B2 Full condensate tank indicator light
B3 Power On indicator light
B4 On/Off button
B5 Plus (+) button
B6 Display
B7 Minus (–) button
B8 Continuous dehumidification
button
BEFORE FIRST USE
■ Before first use, take the appliance and its accessories out of the packaging material
and remove all promotional labels and stickers. Check that neither the appliance nor
any of its parts is damaged.
INSTALLATION LOCATION OF THE APPLIANCE
■ Locate the appliance on an even, dry and stable surface within reach of aproperly
grounded power socket.
■ Do not use the appliance outdoors.
■ To ensure sufficient air circulation, leave at least 20 cm of free space around the sides
of the appliance.
■ Locate the appliance in a room where temperature does not fall below 5 °C. If
the temperature were to fall below 5 °C, there is arisk of frost forming inside the
appliance, which would reduce its efficiency.
■ Do not locate the appliance in the vicinity of dryers, heating devices and other
sources of heat.
■ Use the appliance in locations where humidity could damage books or other
valuable items.
■ The appliance must be used in a closed room in order to ensure its maximum
effectiveness. Therefore, close the doors and windows of the given room.
OPERATING THE APPLIANCE
■ The dehumidifier is used for drying out, for example, flooded basements, rooms
with an increased level of moisture, etc. Do not use it in areas where substances or
items are stored requiring precise room temperature and humidity control.
■ If using the appliance for the first time, it is important to allow it to run continuously
for 24 hours.
■ Use the appliance at an ambient temperature in the range 5°C–32°C(41 °F–90 °F)
and humidity in the range 30 %-80 %.
■ Always wait at least 3 minutes before turning the appliance on again.
■ Do not connect the appliance to a power socket to which another appliance is
already connected. We recommend connecting the appliance to an independent
circuit.
■ Make sure that the condensate tank is correctly installed in the appliance, otherwise
the appliance may not function correctly.
OPERATING THE APPLIANCE
■ Make sure that the appliance is located in asuitable place and that it is correctly
assembled. Then insert the power plug into apower socket.
Turning on / o
■ Press button B4 to turn on the appliance. The indicator light B3 will turn on. In order
to turn off the appliance, press button B4 again and indicator light will turn off.
■ The appliance will turn off automatically if the condensate tank A6 is full or
incorrectly installed.
■ If you turn the appliance off and then need to turn it on again quickly thereafter, the
appliance will start again after approximately 3 minutes. This function protects the
compressor against damage.
■ The appliance is equipped with an automatic restart function (AUTO-RESTART)
for the event of apower outage. Settings will remain stored in the memory of the
appliance, and after power is restored, the appliance will automatically start in the
previously set mode.
■ When you have finished using it, turn off the appliance and disconnect the power
cord from the power socket.
Display
■ The display B6 shows: set humidity in % (range: 35 % - 85 % actual humidity in %
(+/- 5 % in the range 30 % - 90 % relative humidity). In the event of amalfunction,
the display will also show error messages.
Setting the continuous dehumidication mode
■ The CONT. B8 is used to turn the continuous dehumidification mode on and off. The
On state is signalled by indicator light B1 being lit.
■ In this mode, the appliance runs continuously until the condensate tank A6 is completely
full of condensate. Aspecific humidity cannot be set.
Setting the humidity
■ Use buttons +/- to set the required humidity in the range 35 % - 85 % RH (relative
humidity). Each time abutton is pressed, the value will increase or decrease by 5 %.
The set humidity will be shown on the display B6.
Full condensate tank indicator
■ When the indicator light B2 is lit on the control panel A1, the condensate tank A6 is
full and the condensate needs to be emptied out. The appliance will stop running.
■ Empty out the condensate tank according to the instructions in chapter „Draining
condensate into the tank“ After installing the condensate tank the appliance will
automatically start up again.
Automatic defrosting
■ In the event that frost forms around the vaporizer coil, the appliance will
automatically switch to the automatic defrost mode until it eliminates the frost.
In this mode, the compressor will turn on in regular intervals and the fan will run
continuously.
Draining condensate into the tank
■ Prior to turning on the appliance, check that outlet A9 is fitted with aplug.
■ During operation, condensate will accumulate in the tank A6. As soon as it fills up,
the indicator light B2 will be lit and the appliance will turn off automatically. Error
message „P2“ will appear on the display B6.
■ Carefully slide out the condensate tank, careful not to spill any water. Use the side
indents A5 to slide out the tank. The bottom of the condensate tank is not level,
therefore do not stand it on the floor when the condensate tank is full. Empty out
the condensate tank and insert it back into the appliance. Check that the condensate
tank is correctly installed. The appliance will automatically resume operation.
■ When removing the condensate tank, be careful so as not to drop it and damage
the internal parts of the appliance. Do not use excessive force when installing the
condensate tank into the appliance. Using brute force may damage the appliance.
■ If there is any water in the installation area of the condensate tank, wipe it using
adry wiping cloth.
Continuous condensate draining via the drain hose
■ For continuous draining of condensate, screw off the plastic plug anticlockwise from
the drain hose outlet A9. Carefully store the plug for future use.
Note:
If there is water in the outlet when the plug is removed, wipe it using
adry wiping cloth.
■ Properly screw in the threaded end of the drain hose to the outlet. To ensure that
condensate does not leak, check that the hose end is properly screwed in.
■ Locate the free end of the hose so that the condensate can flow out freely. The
container or place where the condensate is drained must be lower than the outlet.
Do not bend or twist the hose.
■ Set the required humidity and fan speed to start the appliance.
Note:
When not using the drain hose for continuous draining of condensate,
screw off the hose, wipe away nay water and close the outlet using the
plug.
CLEANING AND MAINTENANCE
■ Disconnect the power plug from the power socket before cleaning.
Note:
For cleaning, do not use cleaning products with an abrasive effect,
solvents, etc. that could damage the appliance.
Warning:
To prevent the risk of injury by electrical shock, do not submerge
the appliance, power cord or power plug in water or any another
liquid.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SDH 1020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SDH 1020 in the language / languages: English as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info