12
Please read the following instruction carefully before using your freezer.
-Do not put hot food inside the freezer.
-Wrap all food items with a plastic protection film to avoid dehydration and lose
food flavor.
-If you do not use the freezer for a long period of time, disconnect power, clean
the inside parts, put the freezer in a dry area and leave the door slightly open.
Ⅰ. GENERAL
TTF 990A+ is extensively used in places such as hotels, offices, houses and
student dormitories. It is mostly suitable for freezing and conserving foods such
as meat etc. It enjoys the advantage of small size, light weight, high efficiency and
low energy consumption.
Ⅱ.UNPACKING, REPACKING AND MOVING
1. Unpacking
Just cut off the packing band, and then pull the carton up.
2. Repacking
Please remember to put the original foamed pads in place.
3. Moving
Be sure freezer stays in upright position during moving it.
Do not tilt it for more than 45°from upright. Never upset it.
Do not apply force on any external part such as pipe, condenser, door and its
handle for moving, freezer must be well packed and secured in long distance
transportation to avoid damage from impacting and or great rocking.
Ⅲ. INSTALLATION
The freezer should be placed on a flat and solid-top surface. It should be kept
away from sunlight, heat source, humid or mess place. The freezer should be
kept away from the wall for a proper space for good air circulation. When the
freezer is placed in a cupboard, the rear of the cupboard must be removed out for
good circulation.
For good ventilation keep enough space between the side walls and your fridge.
Its back needs to be at least 100mm away from the wall, its sides at least 100mm
separately and the height from over its top is not less than 200mm. A clear space
should be left to open the door to 160°.
Ⅳ. OPERATION
1. Before the freezer is plugged in, check the following:
-There must not be any damage on all electrical wire, if the supply cord is
damaged, it must be replaced by a special cord or assembly available from the
manufacturer or its service agent.
-Earthing screw must be well fixed.
-Wall outlet must be properly earthed.