Manual SEG CB 102 (page 2 of 7) (English, German, French)

788856

Zoom out

Zoom in

1/7

en Instructions for use

Safety warnings

This product is equipped with

safety features. Nevertheless,

read the safety warnings carefully

and only use the product as de-

scribed in these instructions to

avoid accidental injury or damage.

Keep these instructions for future

reference. If you give this product

to another person, remember to

also include these instructions.

Intended use

The electric cleaning brush is

designed for cleaning suitable

surfaces and objects.

It is not suitable for personal care

or pet grooming.

The product is designed for

personal use and is not suitable for

commercial purposes.

DANGER to children

• The product is not a toy!

Children are not aware of the

risks involved when electrical ap-

pliances are handled incorrectly.

Therefore, keep the product

out of the reach of children.

• Keep the packaging material out

of the reach of children. It poses

several risks, including the risk

of suffocation and injury!

• Swallowing batteries can be fatal.

If a battery is swallowed, it can

cause severe internal chemical

burns and even death within

Product number: 634 125

Electric

Cleaning Brush

122717AB4X3XII · 2022-01

On/off switch

(on the back)

Battery

compartment

Battery com-

partment lid

Drive spindle

Brush

head

Polishing

head

Foam

head

2 hours. Therefore, keep both

new and old batteries and the

product out of the reach of chil-

dren. If you think that a battery

has been swallowed or has got

into the body in any other way,

seek medical advice immediately.

WARNING - risk of injury

• The rotating heads may throw

off dirt particles or cleaning

products. Protect your eyes with

protective eyewear if necessary!

Do not use the device to apply

bleach or any other dangerous

chemicals.

• While in use, keep the device

away from long hair, loose

clothing and similar. These

may get caught in the rotating

heads.

• Single-use batteries must not be

charged, taken apart, thrown into

ﬁre or short-circuited.

• If a battery leaks, avoid contact

with skin, eyes and mucous

membranes. If necessary, rinse

the affected areas with water and

consult a doctor immediately.

CAUTION – material damage

• The cleaning brush corresponds

to protection type IPX5 and is

protected from water spray from

all directions when the battery

compartment is properly closed.

However, do not immerse the

device in water or other liquids.

Ensure that no water penetrates

the device while the device is

being used or cleaned.

Inserting / changing batteries

1. Unscrew the battery

compartment lid.

2. Remove the battery holder.

3. Insert the batteries

provided into the battery

compartment as illustrated,

ensuring that the polarity

is correct (+/–).

4. Replace the battery holder

in the casing.

This only works in one

direction: Also pay attention

to the arrow on the bottom

of the battery holder.

5. Put on the battery

compartment cover and

screw it as far as it will go.

The batteries need replacing when the heads are only rotating slowly or

are not rotating at all. Replace the used batteries with new ones of the

same type (see “Technical speciﬁcations”).

Fitting / changing the heads

CAUTION – material damage

The hard bristles on the brush head can scratch or damage sensitive

surfaces such as glass, car paint, stainless steel, copper, wood, etc.

If in doubt, test the cleaning brush ﬁrst on an inconspicuous part of

the surface you wish to clean.

Choosing a head

Brush head

for rough surfaces

and difﬁcult to reach

joints and gaps

Foam head

to wash smooth

surfaces

Polishing head

to polish smooth

surfaces (marble,

ceramic glaze, stain-

less steel, glass)

Cleaning the device

CAUTION – material damage

• When the battery compartment is properly closed, the device is

protected against water splashes. However, do not immerse it in

water or other liquids. Ensure that no water gets into the drive axle.

• Do not use abrasive or caustic products, or hard brushes, etc. for

cleaning the device.

1. Clean the heads under

warm running water

with a mild cleaning

product, as illustrated.

Then rinse them

thoroughly with clean

water.

The polishing head can

also be directly washed

and rinsed in warm

water.

2. Leave the heads and in particular the polishing head to dry

completely before storing the device.

3. Wipe the handle with a slightly dampened cloth.

Disposal

This product, its packaging and the supplied batteries have been manu-

factured from valuable materials that can be recycled. This reduces the

amount of refuse and helps to preserve the environment.

Dispose of the packaging at a recycling point that sorts materials by

type. Make use of the local facilities provided for collecting paper, card-

board and lightweight packaging.

Devices marked with this symbol must not be disposed of

along with normal household waste!

You are legally obliged to dispose of old devices separately

from household waste. Electronic devices contain hazardous

substances and, if stored or disposed of improperly, may

cause harm to health and the environment. Information about collection

points where old devices can be disposed of free of charge is available

from your local authorities.

Single-use batteries and rechargeable batteries must not

be disposed of along with household refuse!

You are legally obliged to dispose of all ﬂat batteries at a

local authority collection point or to return them to a battery retailer.

Tape over the contacts of lithium single-use/rechargeable batteries prior

to disposal.

Technical speciﬁcations

Model: CB 102

Product number: 634 125

Batteries: 4x LR6 (AA)/1.5 V (AlMn)

Operating time with

1 set of batteries: approx. 2 hours

IP code: IPX5 (Protection against water spray

from all directions)

Ambient temperature: +10 to +40°C

Manufacturer: Jaxmotech GmbH,

Ostring 60, 66740 Saarlouis, Germany

In the course of product improvement, we reserve the right to make

technical and optical modiﬁcations to the product.

Changing the heads

Pull the previous head

straight off the drive

axle and then push your

desired head straight

onto the drive axle.

To use the polishing

head, pull it over the

foam head.

Using the cleaning brush

WARNING – danger of injury due to rotating parts

• The rotating heads may throw off dirt particles or cleaning products.

Protect your eyes with protective eyewear if necessary!

• While in use, keep the device away from long hair, loose clothing and

similar. These may get caught in the rotating heads.

1. Moisten the bristles (or the surface of the foam head or polishing

head) and apply a suitable cleaning product, if necessary. Gel or

powder cleaning products are better suited to use with the device

than thin ﬂuids.

You can also spray the surface you wish to clean with a spray cleaner,

for example.

2. Place the device on the area that is to be cleaned.

3. To switch the device on,

press the on/off button.

4. Slowly move the cleaning

brush over the surface.

5. To switch the device off,

press the on/off button

again.

• Do not use the device on sensi-

tive surfaces which are not suita-

ble to be treated with the clean-

ing brush. The hard bristles on

the brush head can scratch or

damage sensitive surfaces such

as glass, car paint, stainless steel,

copper, wood, etc. If in doubt,

test the cleaning brush ﬁrst on

an inconspicuous part of the

surface you wish to clean.

• Protect the batteries from

excessive heat. Remove the

batteries from the product

when they are ﬂat or if you do

not intend to use the product

for a prolonged period.

This will prevent damage caused

by leakage.

• Always replace all batteries at

the same time. Do not mix old

and new batteries and do not

use different types or brands

of batteries, or batteries with

different capacities.

When inserting the batteries,

ensure correct polarity (+/–).

• Clean the contacts on the batter-

ies and device as required before

insertion. Risk of overheating!

• Do not use abrasive or caustic

products, or hard brushes, etc.

for cleaning the device.

122717 2s Elektrische_Reinigungsbuerste_de-en_v4a.indd 2

23.02.22 07:48

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of SEG CB 102 in the language / languages: English, German, French as an attachment in your email.

The manual is 4.77 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

SEG CB 102 Manual

Product: