676461
31
Zoom out
Zoom in
Previous page
1/58
Next page
Barracuda 5400.1 Product Manual, Rev. C 23
3.3 Jumper settings
3.3.1 Master/slave configuration
The options jumper block shown in Figure 4 is used to configure the drive for
operation. It is the 8-pin dual header between the interface connector and the
power connector. Use the following settings to configure the drive as a master
or a slave.
Master or single drive. The drive is configured at the factory for a master or
single-drive operation with a jumper set on pins 7 and 8.
Drive as slave. Remove all jumpers.
Drive as master with a non-ATA-compatible slave.
Set a jumper on pins 5 and 6 and another jumper on pins 7 and 8. Use this
jumper setting only if the drive does not work as a master with no jumpers
installed.
Figure 4. Master/slave jumper settings
3.3.2 Cable select option
Computers that use cable select determine the master and slave drives by
selecting or deselecting pin 28, CSEL, on the interface bus. Master and slave
drives are determined by their physical position on the cable. To enable cable
select, set a jumper on pins 5 and 6 as shown in Figure 4. Refer to your
computer manual to determine whether your computer supports this option.
Options jumper block
2
684
1753
Drive is slave
Master or single drive
Cable select
Master with non ATA-
compatible slave
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Seagate Barracuda 5400.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Seagate Barracuda 5400.1 in the language / languages: English as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info