MOUNTAIN BIKE AND MOUNTAIN BIKE-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2017ORIGINAL OPERATING INSTRUCTIONS 2017 | MOUNTAIN BIKE AND MOUNTAIN BIKE-PEDELEC
| 44
bcaefd
In its end position the quick-release lever should be tight so that it can no longer
be turned. Make sure the quick-release lever does not stand out to the front or
to the side (e). The best closing position is in nearly upright position in front of
the lower leg (f).
Wheel removal
If you have an E-Thru 15 mm thru-axle system, open the quick-release lever fully.
Subsequently, turn the thru axle anticlockwise.
When the thru-axle thread no longer engages with the thread of the lower legs,
you can remove the thru axle fully.
NOTE!
i
More information are provided at www.ridefox.com
Fox E-Thru 15 QR
Wheel mounting
If you have an E-Thru 15 mm thru-axle systems (a), put the front wheel into the
fork and slide in the brake disc into the brake calliper at the same time.
Bring the front wheel into the right position between the drop-outs and slide
the axle with the E-Thru-quick-release lever open from the left side through the
drop-out and the hub (b).
When the axle thread engages with the thread of the right fork leg, turn the
axle clockwise (c). During the first turns you should be able to turn the thru axle
nearly without resistance. Tighten the axle slightly.
Close the E-Thru quick-release lever like a usual quick-release lever.
When you start closing the lever you should feel virtually no resistance with
your hand, during the second half of the way the resistance you feel should in-
crease significantly and towards the end even more strength is required to close
the lever.
In case you do not succeed in closing the lever fully, re-open it and turn the axle
a little anticlockwise. Try again to close the quick-release lever.
Use the palm of your hand while your fingers pull on the fork leg (d), but never
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Scott MTB - 2016 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Scott MTB - 2016 in the language / languages: English as an attachment in your email.
The manual is 4,7 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
