123361
20
Zoom out
Zoom in
Previous page
1/60
Next page
18
GB
You decide when it starts.
When you have loaded the dishes, you can choose when to
start your dishwasher before setting the wash cycle desired.
Press button “M” (Mode) and then select the symbol
"F"corresponding to the delayed start:
the corresponding rectangle will darken. Now press button
S” (Select) to delay the wash cycle start by 1 to 24 hours. If
you press the button again, the word “OFF” is displayed (no
selection made).
Each time the button is pressed, a beep will sound; once you
have made your selection, make sure the appliance door is
shut and start the wash cycle by pressing button "D" (START).
The countdown to the delayed start will begin on the display.
Once the countdown is up, the wash cycle begins and the
approximate amount of time left until the end of the wash
cycle is displayed.
Have you changed your mind?
If you change your mind and wish to set a different delay
press the Mode and Select buttons and repeat the selection.
If on the other hand you want to cancel the delay set and
you wish to start the wash cycle immediately, press the Select
button repeatedly until it is set to zero. The indicator light
"F"will turn off.
Delayed start , Extra drying and Half load
Do you want extra drying?
Before you start the selected wash cycle, press button “M
(Mode) repeatedly until the extra drying symbol “G” is
selected, and the corresponding rectangle lights up. Press
button “S” (Select) and select On to enable the extra drying,
or Off to disable it. Remember that with the extra drying
enabled, the wash cycle will last longer to provide you with
dryer dishes.
This option is incompatible with the soak cycle.
You want to wash just half a load?
Remember to halve the amount of detergent.
Have you only got a few dishes that need washing? If so,
load them all on a single rack to save on water, detergent
and electricity. Press the "M" (Mode) button repeatedly until
symbol “N” is selected: the corresponding rectangle will light
up. Using button S (select), you can decide to wash a half-
load on the upper rack or on the lower one .
Each time you press it, a beep will sound and the
corresponding symbol will light up. The symbol for the selected
rack is displayed. Off means “no selection” has been made
Once you have made your selection, start the wash cycle by
pressing START.
This option is available with all wash cycles.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scholtes lvi 1266 mgi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scholtes lvi 1266 mgi in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info