Manual Scholtes lvi 1266 mgi (page 19 of 60) (English, German, Dutch, French, Italian)

123361

Zoom out

Zoom in

1/60

Turning on the Appliance

First of all.

Insert the plug into the electricity socket to power the

dishwasher. Turn on the water tap completely and press the

Stand-by button "A".

The display turns on and 4 dashes appear: these indicate

that the dishwasher is awaiting instructions.

Starting and selecting the cycle.

To select the wash cycle, turn knob "P" clockwise; the

corresponding symbols will light up in sequence:

choose the cycle you deem most suited to the type of dishes

to be washed (take a look at page 19, where you will find

the wash cycle table).

Keep the Start "D"button pressed for a few seconds and

the wash cycle begins, but if you have left the dishwasher

door open, the word “DOOR” will be displayed; shut it and

press the same button again.

A beep sounds and then the wash cycle begins and only the

symbol corresponding to the wash cycle selected is displayed.

You can see the amount of time left until the end of the

wash cycle on the counter. Do not expect a precise countdown

as the wash cycle starts with an estimated cycle time that is

updated, thanks to the sensor it is fitted with, as the cycle

progresses, according to a number of parameters that ensure

maximum wash efficiency.

Cycle phase indicator lights

The dishwasher is provided with 4 indicator lights "H" which

come on in sequence as the appliance is performing that

specific phase of the wash cycle.

These phases are:

Cancelling or modifying a wash cycle in progress…..

You can modify the wash cycle in progress, if it has only just

started. Keep the Reset button "D" pressed for about 3

seconds: a prolonged beep will sound, followed by three

short beeps. Indicator light “I” turns off and the 4 dashes

appear to indicate that all the settings have been cancelled.

You are now free to re-set the correct wash cycle.

If you have left out a dish…

Interrupt the wash cycle by pressing the Stand-by button,

insert the dish you had forgotten and press the same button

again. The cycle will start up from where you interrupted it.

There's been a power failure? Have you opened the

dishwasher door?

The wash cycle stops and then restarts when the electricity

comes back on or when you shut the door.

Have you left the dishwasher door open?

The word “DOOR” flashes on the display. Shut the appliance

door and the wash cycle will start up again.

At the end of the wash cycle….

The end of the wash cycle is indicated by two short beeps

and the word “END” flashes on the display.

• Turn off the water tap.

• Wait a few minutes before unloading the dishes: they are

very hot! If you wait a little while, they dry better.

• Empty the lower rack first.

Make sure the wash cycle has ended before removing the

dishes!

Warning:

If opening the door soon after the end of the programme, or

during it, stand away from the Dishwasher, to avoid possible

injury from hot steam.

“Duo Wash” Cycle:

This is a special cycle that runs a differentiated wash on the

two racks: delicate for glassware and glasses on the upper

rack and heavy duty for saucepans and frying pans on the

lower rack.

Press the (Mode) button "M"and select the Duo-Wash

symbol, then press "S" (Select):“on” means it is selected

and the corresponding rectangle will light up, whereas “off”

means it is disabled; after approx. 5 seconds, you will

automatically quit the menu.

Now press Start and the wash cycle starts with a beep.

pre-wash

wash

rinses

drying

Warning:

Turn the display off by pressing button “A”, unplug the

appliance from the electricity socket to cut off the power

supply; the power supply cable should consequently be

easily accessible.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scholtes lvi 1266 mgi in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,48 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scholtes lvi 1266 mgi Manual

Product: