Manual Scholtes hp 95 (page 15 of 48) (English, German, Dutch, French, Italian, Spanish)

128412

Zoom out

Zoom in

1/48

D) Carbon Filter Replacement

For your hood to operate at its best, the activated

carbon filters must be replaced on a regular basis, at

least once every three months. To buy these, contact

an Authorised Service Centre or the Retailer where

you purchased it. Before you begin to insert the

carbon filter, put the omnipolar switch on the O

position (OFF). Pull the lever on the metal filter until

it is released from its housing then remove it by

pulling it downwards (fig. 7). Remove the soiled

activated carbon filters “O“ by turning them clockwise

and then removing them from the guide pegs on the

outdoor venting assembly.

Fit the new filters on, making sure the holes located

on the same fit well around the special reference

pegs of the outdoor venting assembly (fig. 8) and turn

them anti-clockwise until you hear them click

(opposite action to the one for dismounting).

E) Special Functions (for cooker hoods with touch

control panel):

The electronic controls fitted to your hood are

provided with advanced functions to facilitate

maintenence and improved use of the product.

Message indicating that the carbon filters require

replacing

(For mod. HP 97):

If the hood purchased is used in the filter version,

with carbon filters to purify exhaust fumes, the

microprocessor of the elettronic system must first be

informed that it is managing an instrument in filter

mode. To do this, switch off the hood, press and hold

key n° 4 for more than 5 seconds. When the key is

pressed “-” appears on the display (indicating that the

hood is not using the carbon filter). After 5 seconds

this becomes a “C” (indicating that the hood is using

the carbon filters). From now on every 120 hours of

use the microprocessor indicates that the carbon

filters should be replaced with a flashing “C” on the

display, this consents the exhaust to function better

and improves hygiene in the room. To cancel the

warning message after replacing the carbon filter,

switch off the hood switched, press and hold key n°3

for more than 5 seconds, when the key is pressed

the letter “C” appears on the display and after 5

seconds this disappears and the microprocessor

starts a new 120-hour count-down before displaying

the next warning message.

Operating Modes

Outdoor venting

After fastening the "motor connection" as illustrated

in the relative paragraph, connect the same to the

steam and odour exhaust duct by means of a pipe of

a suitable diameter and a minimum cross-section of

150 cm ². If this exhaust duct is not available and the

hood needs to be installed on one of the building's

external walls, make a hole in the wall large enough

to fasten a rain- and wind-proof grille to it, with a

minimum cross-section of 150 cm ² and connect it to

the "motor connection" with a pipe.

Air Recirculation

The hood can be operated in air recirculation mode if

it is not possible to connect an exhaust duct to the

outside. In this case, the air is recirculated by

opening "R" (fig. 1). For the operation of the hood in

air recirculation mode, two activated carbon filters

must be used to absorb all cooking odours. The

assembly instructions are given in the "Carbon Filter

Replacement" paragraph.

Fig. 7

Fig. 8

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scholtes hp 95 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,18 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scholtes hp 95 Manual

Product: