Manual Scheppach SG7000 (page 87 of 128) (English, German, French, Italian)

781621

Zoom out

Zoom in

1/128

Pour the recommended engine oil into the oil ller hole.

Note! Screw the oil ller cap (A) on tightly.

Recommended engine oil: SAE 10W-30

Capacity: approximately 1,1 litres

Dispose of the drained oil properly at a local used

oil collection point. Dumping used oil in the soil or

mixing it with waste is prohibited.

Important note in case of repair:

When returning the generator for repair, for safety rea-

sons, ensure that it is free of oil and petrol when it is

sent to the service centre.

Clean the fuel lter

1 Clean the lter with a solvent.

2 Wash the solvent off.

3 Re-insert the fuel lter

Check the spark plug

Switch off the engine and allow it to cool.

Caution! Danger of burning

Clean or replace spark plug as required:

1 Remove the spark plug connector and clean any dirt

from the spark plug area.

2 Unscrew the spark plug and check it.

3 If there is any damage, e.g. cracks or chips, replace

the spark plug.

4 Clean the spark plug electrodes with a wire brush.

5 Check and set the electrode gap (0,6 mm)

6 Screw the spark plug in and tighten with the spark

plug spanner.

7 Place the spark plug connector on the spark plug

When replacing, ensure that no dirt gets into the

cylinder head.

Check the t of the spark plug.

A loose spark plug can cause damage to the engine by

overheating.

Pulling too hard can damage the thread in the cylinder

head.

The manufacturer is not responsible for the resulting

damages; the user solely bears the risk. Only use the

recommended spark plugs or identical spark plugs.

Clean the air lter Fig. 9

1 Loosen the locking (E) at the bottom of lter cover

(F)

2 Remove the lter cover (F)

3 Clean the foam pre-lter in a non-ammable solvent.

Rabboccare con olio motore raccomandato nel foro di

rabbocco dell‘olio.

Avviso! Avvitare bene il tappo di rabbocco dell‘olio

(A).

Olio raccomandato SAE 10W-30

Quantità di rabbocco circa 0,6 litri

Smaltire conformemente l’olio nei punti di racconta

locali di olio usato. È vietato disperdere l’olio usato

sul suolo o insieme ai riuti urbani.

Avviso importante in caso di riparazione:

In caso di restituzione per riparazione, tenere presente

che il generatore, per motivi di sicurezza, deve essere

rispedito alla stazione di assistenza tecnica senza

olio né benzina.

Pulire il ltro di carburante

1 Pulire il ltro con solvente.

2 Sciacquare il solvente.

3 Riapplicare il ltro del carburante.

Controllare la candela di accensione.

Spegnere il motore e lasciare raffreddare.

Attenzione! Pericolo di ustione.

Se necessario, pulire o sostituire la candela di accen-

sione:

1 Estrarre la spina della candela di accensione e ri-

muovere lo sporco nella zona della candela di ac-

censione.

2 Svitare e controllare la candela d‘accensione.

3 In caso di danneggiamenti come lacerazioni o

schegge, sostituire la candela.

4 Pulire gli elettrodi della candela di accensione con

una spazzola metallica.

5 Controllare e regolare la distanza degli elettrodi.

6 Avvitare la candela di accensione e stringere con la

chiave per candela di accensione.

7 Applicare la spina della candela di accensione sulla

candela stessa.

Accertarsi che durante la sostituzione lo sporco

non raggiunga la testa del cilindro.

Vericare la posizione della candela di accensione.

Una candela di accensione lenta può danneggiare il

motore in caso di surriscaldamento.

Stringendo troppo forte si può danneggiare la lettatura

nella testa del cilindro.

Il produttore non si assume alcuna responsabilità

per i danni risultanti da tale uso. Il rischio è esclu-

sivamente a carico dell‘utilizzatore. Utilizzare solo

candele di accensione raccomandate o simili.

Pulire il ltro dell‘aria Fig. 9

1 Allentare la vite della manopola (E)

2 Rimuovere la copertura del ltro (F)

3 Pulire il preltro di schiuma in un solvente non in-

ammabile.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach SG7000 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 8.64 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach SG7000 Manual

Product: