781925

Scheppach SG2600 Manual

55
Zoom out
Zoom in
Previous page
1/148
Next page
55
MAINTENANCE TASKS
Oil change, g.. 9
Change the engine oil after 25 operating hours, then
after 50 hours or every three months.
1. Drain the engine oil when the engine is hot.
2. Warm the engine up.
3. Switch the engine off.
4. Place a container that is large enough to collect the
used oil under the oil drain screw (D).
5. To drain the oil, remove the oil ller cap (A) and the
oil drain screw (D).
6. Drain the oil
7. Re-attach the oil drain screw (D) with a sealing
washer and tighten.
Pour the recommended engine oil into the oil ller hole.
Note! Screw the oil ller cap (A) on tightly.
Recommended engine oil: SAE 10W-30
Capacity: approximately 0.6 litres
Dispose of the drained oil properly at a local used
oil collection point. Dumping used oil in the soil or
mixing it with waste is prohibited.
Important note in case of repair:
When returning the generator for repair, for safety rea-
sons, ensure that it is free of oil and petrol when it is
sent to the service centre.
Clean the fuel filter
1 Clean the filter with a solvent.
2 Wash the solvent off.
3 Re-insert the fuel filter
Check the spark plug
Switch off the engine and allow it to cool.
Caution! Danger of burning
Clean or replace spark plug as required:
1 Remove the spark plug connector and clean any dirt
from the spark plug area.
2 Unscrew the spark plug and check it.
3 If there is any damage, e.g. cracks or chips, replace
the spark plug.
4 Clean the spark plug electrodes with a wire brush.
5 Check and set the electrode gap.
6 Screw the spark plug in and tighten with the spark
plug spanner.
7 Place the spark plug connector on the spark plug.
When replacing, ensure that no dirt gets into the
cylinder head.
Check the t of the spark plug.
A loose spark plug can cause damage to the engine by
overheating.
Pulling too hard can damage the thread in the cylinder
head.
LAVORI DI MANUTENZIONE
Cambio dell‘olio, g. 9
Sostituire l’olio motore dopo le prime 25 ore di esercizio,
successivamente ogni 50 ore o ogni tre mesi.
1 Far scaricare l’olio motore con il motore caldo.
2 Lasciare funzionare a caldo il motore.
3 Spegnere il motore.
4 Posizionare un contenitore sufcientemente grande
per raccogliere l’olio usato sotto alla vite di scarico
dell’olio (D).
5 Per scaricare l’olio, rimuovere il tappo di rabbocco
dell’olio (A) e la vite di scarico dell’olio (D).
6 Far scaricare l‘olio
7 Riapplicare la vite di scarico dell‘olio (D) con fascetta
di tenuta e stringere.
Rabboccare con olio motore raccomandato nel foro di
rabbocco dell‘olio.
Avvertenza! Avvitare bene il tappo di rabbocco
dell‘olio (A).
Olio raccomandato SAE 10W-30
Quantità di rabbocco circa 0,6 litri
Smaltire conformemente l’olio nei punti di racconta
locali di olio usato. È vietato disperdere l’olio usato
sul suolo o insieme ai riuti urbani.
Avvertenza importante in caso di riparazione:
In caso di restituzione per riparazione, tenere presente
che il generatore, per motivi di sicurezza, deve essere
rispedito alla stazione di assistenza tecnica senza
olio né benzina.
Pulire il filtro di carburante
1 Pulire il filtro con solvente.
2 Sciacquare il solvente.
3 Riapplicare il filtro del carburante.
Controllare la candela di accensione
Spegnere il motore e farlo raffreddare.
Cautela! Pericolo di ustione
Se necessario, pulire o sostituire la candela di accen-
sione:
1 Se necessario, pulire o sostituire la candela di ac-
censione:
2 Estrarre la spina della candela di accensione e ri-
muovere lo sporco nella zona della candela di ac-
censione.
3 Svitare e controllare la candela d‘accensione.
4 In caso di danneggiamenti come lacerazioni o scheg-
ge, sostituire la candela.
5 Pulire gli elettrodi della candela di accensione con
una spazzola metallica.
6 Controllare e regolare la distanza degli elettrodi.
7 Avvitare la candela di accensione e stringere con la
chiave per candela di accensione.
Applicare la spina della candela di accensione sulla
candela stessa.
Accertarsi che durante la sostituzione lo sporco non
raggiunga la testa del cilindro.
Vericare la posizione della candela di accensione.
… 55 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach SG2600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach SG2600 in the language / languages: English, German, Dutch, French, Italian, Polish, Swedish, Norwegian as an attachment in your email.

The manual is 9.18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info