782078

Scheppach PT 106 Woodster Manual

15
Zoom out
Zoom in
Previous page
1/116
Next page
15
Proper Use
The machine meets the requirements of the valid EC •
machine directive.
Before starting to work, all guards and safety devices •
must be fitted to the machine.
The machine has been designed to be operated by •
one person. The operator is responsible opposite third
parties for all dangers emanating from the machine in
the working area.
Observe all safety instructions and warnings attached •
to the machine.
See to it that safety instructions and warnings attached •
to the machine are always complete and perfectly
legible.
The planer/thicknesser with its tools and accessories •
offered has exclusively been designed for the treatment
of wood.
When working with the standard equipment, the work •
pieces must not exceed the table size. Passage width
254 mm, passage height 158 mm.
Larger work pieces that could tilt from the table top •
require the use of a table length extension or a roller
stand (optional equipment).
When used in enclosed rooms, the machine must be •
connected to a dust extractor unit to remove wood
chips and sawdust. The air flow rate at the suction
connector must be 20 m/s.
For work in commercial spaces, a dust extractor unit •
must be used that meets commercial requirements.
Never switch off or remove dust extractor units with •
the main machine running.
The machine must only be used in technically perfect •
condition in accordance with its designated use and
the instructions set out in the operating manual. Any
functional disorders, especially those affecting the
safety of the machine, should therefore be rectified
immediately.
The safety, working and maintenance instructions of •
the manufacturer, as well as the dimensions stated in
the chapter Technical Data, must be observed.
Relevant accident prevention regulations and other, •
generally recognized safety-technical rules must also
be adhered to.
The machine may only be used, maintained, and •
operated by persons familiar with it and instructed
in its operation and procedures. Arbitrary alterations
to the machine release the manufacturer from all
responsibility for any resulting damage.
The machine may only be used with original accessories •
and original tools of the manufacturer.
Attention: The use of other tools or accessories than •
stated in the operating instructions, can hold the risk
of injuries.
Any other use exceeds authorization. The manufacturer •
is not responsible for any damages resulting from
unauthorized use; risk is the sole responsibility of the
operator.
Utilisation conforme
La machine est conforme au directive de l’U.E. en vi-
gueur.
Tous les dispositifs de sécurité et de protection doivent •
être montés pour le travail.
La rabo-dégau est conçue pour être maniée par une •
seule personne ayant toute la responsabilité.
Observer toutes les consignes relatives à la sécurité et •
au danger figurant sur la machine.
Veiller à ce que toutes les plaques d’avertissement •
relatives à la sécurité et au danger appliquées sur la
machine soient toujours complètes et bien lisibles.
Le rabot et ses outils doivent uniquement être utilisés •
pour raboter le bois.
Les dimensions maximales des pièces à travailler ne •
doivent pas être plus grandes que la table. Largeur de
passage 254 mm, hauteur de passage 158 mm.
Avec des pièces de travailler très grandes qui pourraient •
basculer, il faut employer une rallonge de table ou une
servante (équipements optionnels).
Si la machine est utilisée dans des locaux fermés, •
elle doit être reliée à un dispositif d’aspiration. Faire
toujours aspirer les copeaux de bois et la sciure. La
vitesse de flux à la buse d’aspiration doit être de 20
m/s.
Pour l'aspiration lors de travaux relevant du domaine •
professionnel, utiliser une dépoussiéreur autorisé à ce
but.
Ne pas arrêter ou retirer les installations d’aspiration •
ou dépoussiéreurs lors du fonctionnement de la
machine-outil.
Utiliser la machine uniquement lorsqu'elle est en •
parfait état du point de vue technique et conformément
à son emploi prévu en observant les instructions de
service, en tenant compte de la sécurité et en ayant
conscience du danger. Eliminer notamment (ou faire
éliminer) immédiatement toute panne susceptible de
compromettre la sécurité.
Les consignes de sécurité, de travail, et d’entretien •
du constructeur ainsi que les dimensions qui sont
indiquées dans les données techniques, doivent être
respectées.
Respecter les consignes de prévention antiaccidents •
appropriées, ainsi que les autres règles de sécurité
techniques reconnue en général.
Utilisation, entretien, mise en condition de la machine •
uniquement par des personnes familiarisées et qui
sont informées des dangers inhérants. Toute initiative
de modification de la machine exclut la responsabilité
du constructeur pour les dommages y faisant suite.
La machine doit être utilisée uniquement avec des •
accessoires et des outils d’origine du constructeur.
Attention: L'utilisation d'autres outils et accessiores •
que ceux-ci spécifiés dans le manuel, peut causer des
blessures.
Tout autre genre d'utilisation est considéré comme •
non conforme. Le constructeur n’assume pas de
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach PT 106 Woodster at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach PT 106 Woodster in the language / languages: English, German, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 5.58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info