781484
26
Zoom out
Zoom in
Previous page
1/148
Next page
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
26 |
• m WARNING!   
-

-
tached in the knife block.
The knives must not project more than a maximum
of 1 mm out of the knife block.


Never cut concavities, tenons or shapes.



9. Installation
9.1 Stable fastening of the planing machine
(g. 9 + 10)
        
screws.



9.2 Feed (12) and discharge table (6) (g. 3)
-
ed and is folded upwards when packaged.

9.3 Installing the height adjustment crank (4)
(g. 4)




-


at the height adjustment crank while doing this.
󰀩

9.4 Removing the transport protection and pro-
tective foil (g. 5 + 6)
-


     

9.5 Fitting the suction hose (27) (g. 7 + 8)
󰀩
back of the machine using 2 knurled screws for the
       



9.6 Stowing the push stick (g. 11+12)
          -
         

stowed close to the machine.
10. Operation
m ATTENTION! Always make sure the device is
fully assembled before start-up!
m ATTENTION! Disconnect the mains plug before
carrying out any maintenance, cleaning or adjust-
ment work.
m IMPORTANT!: The surfacing and thicknessing

wood.

        

workpieces, the machine must be secured in place


        
󰀨
machine.
      
         


m ATTENTION! The machine starts when the over-
load protection button is pressed in!
To work on long workpieces, use roller tables or
a similar supporting arrangement. Such optional

     
plane. Their height must be adjusted such that the
workpiece is horizontal when it is fed into and out
of the machine.
10.1 Adjusting to the desired height (g. 13)
  

        


         -


height.
1 rotation of the height adjustment crank corre-
sponds to about 2mm of height adjustment.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach PLM1800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach PLM1800 in the language / languages: English, German, French, Italian, Polish as an attachment in your email.

The manual is 6.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info