782088
17
Zoom out
Zoom in
Previous page
1/36
Next page
english 15
forward by 2 to 3 mm. Make this checking for each cutter
on the right and left side of the cutter.
It is impossible to obtain a good planing and surfacing re-
sult when this adjustment is not done with precision.
•Screw the fixing screws of the tightening wedge shaped
parts well with a wrench SW 6 at 8,9 Nm.
•Adjust and tighten all cutter blades in the same way.
•After each replacement of the cutter blades perform a test
running and tighten again the fixing screws at 8,9 Nm.
Before starting the cutter block make sure that all instruc-
tions given above have been followed.
While using the machine follow all general security instruc-
tions of this manual.
Grinding of planer knives
Dull planer knives increase the risk of accident. The
operation efficiency is no longer guaranteed.
Regrind the planer knives only up to 16 mm of the height
of the knives. The cutting angle of the knife should have
40 ± 2 grade.
The re-grinding of the planer knives has to be done
by an authorised firm or send the knives back to the
manufacturer.
Scheppach Fabrikation von Holzbearbeitungsmaschinen
GmbH
Günzburger Straße 69
0-89335 Ichenhausen / Germany
Planer blades:
Plana 3.0c
1 Set planer blades 250: 330 Plana 3.0c 702
1 Set reversible planer blades 250: 330 Plana 3.0c 703
1 Set knife carriers 250: 330 Plana 3.0c 704
Plana 4.0c
1 Set planer blades 310: 330 Plana 4.0c 702
1 Set reversible planer blades 310: 330 Plana 4.0c 703
1 Set knife carriers 310: 330 Plana 4.0c 704
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach Plana 4.0 C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach Plana 4.0 C in the language / languages: English, German, French as an attachment in your email.

The manual is 5.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info