781958
9
Zoom out
Zoom in
Previous page
1/41
Next page
english 9
Manufacturer
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Germany
Dear customer
We hope you have a lot of fun and success using your
new machine.
Note:
Under current product liability regulations, the manufac-
turer of this equipment will not be liable for damages to
the equipment or caused by it in the case of:
• improper handling,
• failure to observe the operating instructions,
• repairs by third parties, non-authorised technicians,
• installation of and replacement by non-original spare
parts,
• non-intended use,
• failures of the electrical system while not adhering
to the electrical regulations and regulations of the
VDE (German Association for Electrical, Electronic
and Information Technologies) 0100, DIN 57113 /
VDE0113.
Our recommendations:
Read the entire text of the operating instructions before
installation and operation.
These operating instructions are to help you to get to
know your machine and its intended fields of application.
The operating instructions contain important notes on how
to work safely, properly, and efficiently with the machine
and how to avoid hazards, save costs of repairs, keep
downtimes short und improve reliability and product life
of the machine.
In addition to the safety instructions in this manual, you
must observe all regulations of your country applicable
for the operation of the machine.
Keep the operating instructions close to the machine,
protected by a plastic envelope against dirt and humidity.
Any operator must read the operating instructions prior
to work and follow them precisely. Only people trained to
operate the machine and who are aware of the associated
dangers are permitted to work with the machine. The
required minimum age must be observed.
General Notes
• After unpacking, inspect all parts for possible transport
damages. In the case of complaints you must inform
the deliverer immediately. Subsequent complaints will
not be accepted.
• Check the shipment to ensure that it is complete.
• Familiarise yourself with the equipment with the help
of the operating instructions before putting the equip-
ment into operation.
• Use only original parts as accessories and spare parts.
You can buy spare parts from your specialist dealer.
• When you order, please state our order numbers as
well as the equipment’s type and year of manufacture.
OX 3–1000
Scope of Delivery
hydraulic log splitter
operating instructions
Specifications
Dimensions D/W/H 830 x 540 x 1560
Table height mm 50/430/810
working height mm 930
log length max cm 600/965/1040/1330
power t* 10
cylinder travel cm 53
forward speed cm/s 4
return speed cm/s 20
oil volume l 9,0
weight kg 154
Noise level at idle
dB(A) 88
Drive
Motor 400 V/50 Hz
input power P1 kW 4,10
output power P2 kW 3,30
duty type S6/40 %
motor speed 1/min 1420
motor protection yes
phase inverter yes
Specifications are subject to change!
* The maximum achievable splitting power depends on the resist-
ance of the material to be split and can, due to influencing vari-
able, deflect to the hydraulic system.
Warning Symbols / Warnings
Please read the manual before start-up
Wear safety footwear
Wear work gloves
Use hearing protection and safety goggles
Wear a hardhat
Authorised personnel only
No smoking in the working area
Do not spill hydraulic oil on the floor
Keep your workspace clean! Untidiness can
cause accidents!
If a crane is used, put the lifting belt round
the housing. Never lift the firewood splitter by
the hand grip,
Dispose of waste oil correctly (waste oil coll-
ection point on site). Do not dump waste oil
in the ground or mix it with waste.
Do not remove or modify protection and
safety devices.
OX 3-1000 2011.indd 9 07.11.11 12:03
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach OX 3-1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach OX 3-1000 in the language / languages: English, German, Dutch, Danish, French, Italian as an attachment in your email.

The manual is 8.61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info