Manual Scheppach MS161-46 (page 31 of 108) (English, German, French, Polish)

781692

Zoom out

Zoom in

1/108

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

GB | 31

• Article number of the machine

Spare parts/accessories

Lawn mower blade - Article no.: 7911200617

Service information

Please note that the following parts of this product

are subject to normal or natural wear and that the fol-

lowing parts are therefore also required for use as

consumables.

Wear parts*: spark plug, air lter, petrol lter, knife,

belt

* Not necessarily included in the scope of delivery!

10. Storage

• Never store the mower (with petrol in the tank) in-

side a building in which petrol fumes could come

into contact with open ames or sparks.

• Allow the motor to cool before you put the lawn

mower in an enclosed area.

• In order to avoid re hazards, keep the engine, ex-

haust and the area around the fuel tank free from

grass, leaves and leaking grease (oil).

Preparing the mower for long-term storage

Caution: Do not empty the petrol tank in enclosed

areas, near re or when smoking. Petrol fumes can

cause explosions and re.

• Empty the petrol tank with a petrol suction pump.

• Start the engine and let it run until any remaining

petrol has been used up.

• Change the oil at the end of every season. To do

so, remove the used engine oil from a warm engine

and rell with fresh oil.

• Remove the spark plug from the cylinder head. Fill

the cylinder with approx. 20 ml of oil from an oil can.

Slowly pull back the starter handle, which will bathe

the cylinder wall with oil. Screw the spark plug back

in.

• Clean the cooling ns of the cylinder and the hous-

ing.

• Be sure to clean the entire machine to protect the

paint.

• Store the machine in a well-ventilated place.

Preparing the mower for transportation (Fig. 22)

• Empty the petrol tank.

• Always let the engine run until it has used up the

remainder of petrol in the tank.

• Empty the engine oil from the warm engine.

• Remove the spark plug boot from the spark plug.

• Clean the cooling ns of the cylinder and the hous-

ing.

• Remove the start tension cable (17) from the hook.

Loosen the quick-release lever (5) and fold the up-

per push bar down.

If the air is very dusty the air lter should be checked

more regularly.

Unclip the air lter cover and remove the sponge lter

element. To avoid objects falling into the air intake,

replace the air lter cover. (Fig. 20).

Important: Never clean the air lter with petrol or in-

ammable cleaning agents. Clean the air lter with

compressed air or simply by knocking out any soiling.

Maintenance of the spark plug (Fig. 21)

Check the spark plug for dirt and grime after 10 hours

of operation and if necessary clean it with a copper

wire brush. Thereafter service the spark plug after

every 50 hours of operation.

Pull off the spark plug boot with a twist. Remove the

spark plug (10) with a spark plug wrench.

Using a feeler gauge, set the gap to 0.75 mm( 0.030”).

Ret the spark plug taking care not to overtighten.

Engine brake lever (Fig. 1)

The engine is equipped with a mechanical brake (3)

which has to be checked regularly. When releasing

the brake lever, the blade must come to a halt within

7 seconds. If this is not the case, the machine must

not be used. Contact an authorised specialist retailer.

Ensure that the machine is in a awless condition for

its entire service life. Improper maintenance may lead

to life-threatening injuries.

Repairs

After any repair or maintenance work, check that all

safety-related parts are in place and in proper work-

ing order. All parts which may cause injury must be

kept where they are inaccessible to children or oth-

ers.

Important: In accordance with product liability legis-

lation we are not liable for any damages caused by

improper repairs or the use of spare parts that are not

original spare parts or parts approved by us.

In addition, we are also not liable for any damages

arising from improper repairs. Such work should be

performed by a customer services workshop or au-

thorized specialist. The same applies to accessory

parts.

Times of use

Please comply with statutory regulations, which may

vary from location to location.

Important hint in case of sending the equipment

to a service station:

Due to security reasons please see to it that the

equipment is sent back free of oil and gas!

Ordering replacement parts

Please quote the following data when ordering re-

placement parts:

• Type of machine

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach MS161-46 in the language / languages: English, German, French, Polish as an attachment in your email.

The manual is 7.65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach MS161-46 Manual

Product: