Manual Scheppach LS40P Woodster (page 18 of 32) (English, German, French)

782006

Zoom out

Zoom in

1/32

18 GB

Adjusting the scarifying depth (Fig.12)

The scarifying depth is set using the depth adjustment

(11). To do this, pull the depth adjuster (11) slightly to the

right and bring it into the desired position and let it snap

into place.

+1 = driving or transport position

0 = 0 mm

-1 = Scarifying depth -2,5 mm

-2 = Scarifying depth -5 mm

-3 = Scarifying depth -7,5 mm

-4 = Scarifying depth -10 mm

-5 = Scarifying depth -12,5 mm

-6 = Scarifying depth -15 mm

Operation

Important!

The engine does not come with oil in it. Therefore,

be sure to add oil before starting the engine. The

oil level in the engine must be checked each time

before carrying out any work.

Starting the equipment

In order to avoid any unintentional start-ups of the

engine, it comes equipped with an engine brake

(Fig. 1/Item 1) which must be pressed at all times

whilst the device is in use, otherwise the engine

will stop. Important: When the engine brake lever is re-

leased it must return to its initial position and the engine

must stop. If this is not the case, do not use the equip-

ment again.

1. Open the petrol cock (Fig. 14 / Item B). Set the

cock to “ON” for this purpose.

2. Set the choke lever (Fig. 14/Item A) to the “Choke”

position. Note: Normally the choke is not required

to restart a warm engine.

3. Move the throttle lever (Fig. 13 / Item 3) to the cen-

tre position.

4. Press the engine brake lever (Fig. 13) and pull the

starter cable (Item 14) forcefully until the engine

starts.

5. Allow the engine to warm up briey and then set

the choke lever (Fig. 13 / Item A) to the “RUN” Posi-

tion.

6. The speed of the cutter unit can be controlled using

the throttle lever (Fig. 13 / Item 3).

Important: Always pull the starter cable slowly

until you feel the initial resistance before you then

pull it quickly to start the engine. Do not allow the

starter cable to whip back of its own accord.

Important: The scarier roller begins to rotate as soon

as the engine is started.

Important! Never open the ejector ap when the motor

is running. A rotating cutting unit can cause injuries.

Always fasten the ejector ap carefully. The ap ips

back to the “Closed” position by the tension springs!

Always ensure that a safe distance (provided by the long

Information concerning noise emission measured

according to relevant standards:

Sound pressure LpA = 85,4 dB(A)

Sound power LWA = 98 dB(A)

Uncertainty KPA = 2 dB(A)

Wear ear-muffs. The impact of noise can cause

damage to hearing.

Vibrations:

Vibration Ahv (left/right) = 6,74 m/s2

Uncertainty KPA = 1.5 m/s2

Keep the noise emissions and vibrations to a mini-

mum.

• Only use appliances which are in perfect working or-

der.

• Service and clean the appliance regularly.

• Adapt your working style to suit the appliance.

• Do not overload the appliance.

• Have the appliance serviced whenever necessary.

• Switch the appliance off when it is not in use.

• Wear protective gloves.

Before starting the equipment

Before you connect the equipment to the mains supply

make sure that the data on the rating plate are identical

to the mains data.

Warning!

The scarier is delivered unassembled. The grass bas-

ket and the complete push bar must be assembled and

mounted before using the scarier. Follow the operating

instructions step-by-step and use the pictures provided

as a visual guide to easily assemble the machine.

Montage

n Important!

You must fully assemble the appliance before using

it for the rst time!

Mounting of the guide rail (Fig. 3 - 9)

• Mount the lower push bar (4) as shown in pictures

3 + 4. Fix the bracket with four hexagon bolts and

the locknuts (E).

• Connect the upper push bar (handle) (1) to the

lower push bar (4). Use the two wing nuts with the

respective screws (5) (Fig. 5 + 6).

• Attach the cable pull retainer (B) to the right side of

the handlebar as shown in Figure 7.

• Fix the cables with the two cable clamps (A) on the

push handle. (Figure 8 + 9)

Mounting the grass catcher (Fig. 10 - 11)

• Lift the ejection ap (Fig. 11 / Item 7) with one hand

and hook in the catching basket (Fig. 11 / Item 6)

with the other hand on the handle from above. At-

tention! To hang the grass catcher, the engine must

be switched off and the roller must not turn!

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach LS40P Woodster in the language / languages: English, German, French as an attachment in your email.

The manual is 3.8 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach LS40P Woodster Manual

Product: