781932

Scheppach LH52 Woodster Manual

17
Zoom out
Zoom in
Previous page
1/83
Next page
17
woods until the log is completely freed.
Oil Change
The hydraulic system is a closed system with oil tank, oil
pump and control valve.
Check hydraulic connections and fittings regularely for air
tightness. Tighten when necessary.
The oil tank has been filled with high quality oil at the
factory.
Replacing hydraulic oil after 150 hours of use
1. Make sure all moving parts stop and the log splitter is
unplugged.
2. Unscrew oil drain screw (11) to remove it.
3. Turn the log splitter on the support leg side as shown
in fig. 5 over a 4 liter capacity container to drain the
hydraulic oil off. Recycle carefully!
4. Turn your Woodster machine on the motor side as shown
in Fig. 6 to refill about 3,8 l fresh oil.
5. Clean the surface of the dip stick on the oil drain bolt
and put it back into the oil tank while keeping the log
splitter vertically. Make sure the level of the refilled oil
is just between 2 grooves around the dip stick.
6. Clean the oil drain bolt before threading it back. Make
sure it is tightened to avoid leakage before placing the
log splitter horizontally. Afterwards start splitting with-
out actually splitting log several times.
Periodically check oil level. Upon low oil level oil refilling
is required.
Dispose of the used oil in a correct manner at a public col-
lection facility. It is prohibited to drop old oil on the ground
or to mix it with waste.
We recommend the following hydraulic oils:
Aral Vitam gf 22
BPEnergolHLPHM22
Mobil DTE 11
Shell Tellus 22
or oils of same quality.
Do not use any other types of oil as they would influence
the function of the hydraulic cylinder.
4. Répéter les étapes précédentes avec de nouveaux coins
de façon à pouvoir extraire le morceau de bois à fendre
de la machine en le poussant vers le haut.
Hydraulique/vidange d’huile
L’installation hydraulique est un système fermé avec ré-
servoir d’huile, pompe à huile et valve de commande. Il
est interdit de le modifier ou manier.
Contrôlerrégulièrement si lesraccordementset les rac-
cords à vis sont étanches, le cas échéant, les resserrer.
Au départ de nos usines, le réservoir d’huile est rempli
d’huile hydraulique de haute qualité à degré
Effectuer une vidange d’huile après toutes les 150
heures de service
1. La plaque de serrage est en position initiale. Déconnec-
ter la machine du branchement secteur.
2. Desserrer la vis de vidange d’huile (11) et la poser de
côté.
3.Poserunecuve41videàcôtédevotremachineWoods-
ter et la redresser, comme montré dans la fig. 5. Atten-
dre jusqu’à ce que toute l’huile ancienne soit écoulée.
Elimination conforme à l’environnement!
4. Renverser maintenant la machine Woodster (Fig. 6) afin
de rajouter env. 3,8 l d’huile hydraulique.
5. Une jauge d’huile est intégrée dans la vis de vidange
d’huile. Essuyer cette jauge et l’introduire dans la ma-
chine encore en position verticale. En la ressortant, un
film d’huile doit alors être visible entre les deux rainu-
res.
6. Resserrer à fond ensuite la vis de vidange d’huile. Ac-
tionner ensuite plusieurs fois la machine lh 52 sans
morceau de bois.
Leniveaud’huiledoitêtrecontrôlérégulièrementetlecas
échéant, il faut rajouter de l’huile.
Eliminez l’huile usagée de manière réglementaire à l’endroit
prévu à cet effet. Il est interdit de déverser de l’huile usagée
dans le solo u de la mélanger à des déchets.
Nous conseillons les huiles hydrauliques suivantes:
Aral Vitam gf 22
BPEnergolHLPHM22
Mobil DTE 11
Shell Tellus 22
ou équivalent.
Eviter d’utiliser d’autres huiles! Utiliser d’autres huiles a
des répercussions sur le fonctionnement du cylindre hy-
draulique.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach LH52 Woodster at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach LH52 Woodster in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 3.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info