644541

Scheppach FS3600 Manual

27
Zoom out
Zoom in
Previous page
1/80
Next page
27
m Electric connection
Check electric cables regularly for damage. Ensure that
during the check, the connecting cable is not connected
to the mains.
Electric connecting cables must conform to the common
VDE- and DIN provisions. Only use connecting cables
with the H 07 RN designation.
Keeping a copy of the type designation on the connect-
ing cable is a specication
Dmaged electric connecting cables
Insulation damages frequently occur on electric connect-
ing cables. The reasons are:
• Pressure points, if connecting cables are routed
through window or door gaps.
• Kinks due to improper mounting or routing of con-
necting cables.
• Intersections due to overruns of connecting cables.
• Insulation damage due to pulling out from wall sock-
ets.
• Cracks due to ageing of insulation.
Such damaged electric connecting cables should not be
used and can be fatal because of the insulation damage
AC motor 230 V/ 50 Hz
Mains voltage 230 Volt / 50 Hz.
Mains connection and extension cable must have
3-wires = P + N + SL. - (1/N/PE).
Extension cables must have a minimum cross-section of
1.5 mm².
The mains connection is secured with a max. 16A fuse.
Maintenance
Caution! Pull out power plug.
• Clean the machine after each work cycle.
• Replace worn out cutting discs.
• Replace damaged protection device
• Dust and pollution must be removed regularly from the
machine. The best way to clean the machine is with a
piece of cloth or brush.
• All moveable parts must be re-lubricated at periodic
intervals.
• Do not use any corrosive substances to clean the
plastic. A damp cloth is sufcient in most cases.
• The tub (4) and coolant pump (13) must be cleaned
regularly to remove dirt, as otherwise the pump or the
pipe or the cooling of the diamond cutting disc (10) is
not guaranteed.
m Raccordement électrique
Vériez régulièrement que les connexions électriques ne
sont pas endommagées. Veillez, lors du contrôle, que la
connexion électrique ne soit pas branchée.
Les connexions électriques doivent satisfaire aux règles
pertinentes VDE et DIN. N’utilisez que des connexions
électriques marquées H 07 RN.
L’empreinte de la désignation du type sur la connexion
électrique est une obligation.
Connexions électriques défectueuses
Des dommages d’isolation surgissent fréquemment sur
les connexions électriques. Les causes en sont:
• Des points de pression lorsque les câbles passent par
des fenêtres ou des portes.
• Des plis causés par une mauvaise xation ou un mau-
vais guidage des câbles.
• Des coupures causées lorsque les câbles sont pié-
tinés.
• Des dommages d’isolation lorsque les câbles sont
arrachés de la prise murale.
• Des ssures causées par une isolation vétuste.
De tels câbles électriques endommagés ne doivent pas
être utilisés et sont extrêmement dangereux en raison
des dommages d’isolation !
Tension de secteur 230 V / 50 Hz.
Le câble de raccordement au réseau et le câble d’exten-
sion doivent être à 3 ls = P + N + SL. - (1/N/PE).
Les câbles d’extension doivent avoir une section mini-
male de 1,5 mm².
Le raccordement électrique est sécurisé avec un fusible
de 16 A maximum.
Entretien
Attention ! Débranchez le connecteur du courant
• Nettoyez la machine à la n de chaque opération.
• Remplacez les disques usés.
• Remplacez tout dispositif de protection endommagé
• Nettoyez la poussière et la saleté de la machine régu-
lièrement. Le nettoyage se fait de préférence avec
un chiffon et un pinceau.
• Toutes les pièces mobiles doivent être lubriées à des
intervalles réguliers.
• Ne pas nettoyer les matières plastiques avec des
agents abrasifs. La plupart du temps, un chiffon hu-
mide suft.
• La vanne (4) et la pompe à eau de refroidissement
(13) doivent être nettoyées régulièrement sinon le
refroidissement du disque diamant (10) ne sera pas
assuré.
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach FS3600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach FS3600 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info