Manual Scheppach DP5000 (page 17 of 64) (English, German, French, Italian)

781912

Zoom out

Zoom in

1/64

Service

Before cleaning, repair, inspecting, or adjusting, shut off

the engine and make certain that all moving parts have

stopped. Disconnect the spark plug wire, and keep the

wire away from the plug to prevent accidental starting.

Have your machine serviced by qualied repair person-

nel using only identical replacement parts. This will en-

sure the safety of the machine maintained.

m Specic Safety Rules

Thoroughly inspect the area to be worked, keep the

working area clean and free of debris to prevent trip-

ping. Operate on a at level ground.

Never place any part of your body where it would be in

danger if movement should occur during

assembly, installation, and operation, maintenance,

repairing or moving.

Keep all bystanders, children, and pets at least 23m (75

feet) away. If you are approached, stop

the unit immediately. Do not mount on dump box and

never carry passengers.

Never park the machine in a place with unstable ground

which could give way, particularly when it is full.

Disengage clutch lever before starting the engine.

Start the engine carefully according to instructions and

with feet well away from the moving parts.

Never leave the operating position when the engine is

running. Always hold the unit with both hands when op-

erating. Keep a rm grip on the handlebars.

Beaware that the machine may unexpectedly bounce

upward or jump forward if the machine should strike bur-

ied obstacles such as large stones.

Walk, never run with the machine.

Do not overload the machine capacity. Drive at a safe

speed, adjusting the speed to the slope of the land, the

surface conditions of the road, and the weight of the

load. Use extreme caution when in reverse or pulling

the machine towards you.

Exercise extreme caution when operating on or cross-

ing gravel drives, walks, or roads. Stay alert for hidden

hazards or trafc.

On soft ground, drive at the rst forward/reverse gear.

Do not rapidly accelerate, turn sharply or stop.

Pay the utmost attention when working on frozen ground

as the machine may tend to skid.

If possible, avoid driving on pebbly river bed, crushed

stone terrains, steel concrete, stumpy eld, logs etc.,

since such operation causes fatal damage or shortens

life span of tracks.

Do not operate the machine in conned areas where

there may be a risk of crushing the operator between

the machine and another object.

Never operate the machine on slopes where angle is

over 20°.

When moving over a slope, whether moving forward or

in reverse, always make certain that the weight is evenly

balanced. Always move in directions parallel with the

slope (up or down). To avoid danger, do not shift gears

on slopes.

Never over ll fuel tank. Fill tank to no more than 12.5mm

(1/2”) below the bottom of the ller neck to provide space

for expansion as the heat of the engine can cause fuel

to expand.

Replace all fuel tank and container caps securely and

wipe up spilt fuel. Never operate the unit without the fuel

cap securely in place.

Avoid creating a source of ignition for spilt fuel. If fuel is

spilt, do not attempt to start the engine but move the ma-

chine away from the area of spillage and avoid creating

any source of ignition until fuel vapors have dissipated.

Store fuel in containers specically designed and ap-

proved for this purpose.

Store fuel in a cool, well-ventilated area, safely away

from sparks, open ames or other sources of ignition.

Never store fuel or machine with fuel in the tank inside

a building where fumes may reach a spark, open ame,

or other sources of ignition, such as a water heater, fur-

nace, clothes dryer and the like. Allow the engine to cool

before storing in any enclosure.

Machine use and care

Position the machine in such a way that it can not move

during maintenance, cleaning, adjustment, assembly of

accessories or spare parts, as well as under storage.

Do not force the machine. Use the correct machine for

your application. The correct machine will do the job bet-

ter and safer at the rate for which it is designed.

Do not change the engine governor settings or over-

speed the engine. The governor controls the maximum

safe operating speed of the engine.

Do not run the engine at a high speed when you are

not working.

Do not put hands or feet near rotating parts.

Avoid contact with hot fuel, oil, exhaust fumes and hot

surfaces. Do not touch the engine or mufer. These parts

get extremely hot from operation. They remain hot for a

short time after you turn off the unit. Allow the engine to

cool before doing maintenance or making adjustments.

If the machine should start to make an unusual noise or

vibration, immediately shut off the engine, disconnect the

spark plug wire, and check for the cause. Unusual noise

or vibration is generally a warning of trouble.

Use only attachments and accessories approved by the

manufacturer. Failure to do so can result in personal in-

jury. Maintain the machine. Check for misalignment or

binding of moving parts, breakage of parts and any oth-

er condition that may affect the machine’s operation. If

damaged, have the machine repaired before use. Many

accidents are caused by poorly maintained equipment.

Keep the engine and mufer free of grass, leaves, ex-

cessive grease or carbon build up to reduce the chance

of a re hazard. Never douse or squirt the unit with wa-

ter or any other liquid. Keep handles dry, clean and free

from debris. Clean after each use. Observe proper dis-

posal laws and regulations for gas, oil, etc. to protect

the environment. Store idle machine out of the reach of

children and do not allow persons unfamiliar with

the machine or these instructions to operate it. Machine

is dangerous in the hands of untrained users.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach DP5000 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 5.06 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach DP5000 Manual

Product: