Manual Schaudt Elektroblock EBL 101 C (page 10 of 16) (English)

629660

Zoom out

Zoom in

1/16

Instruction Manual Electrobloc EBL 101 C

Date: 30.09.2008 811.553 BA / EN

4.1 Battery functions

6-cell lead acid or lead gel batteries, 55 Ah and above

Simultaneous charging of the starter battery and the living area battery via

the alternator, parallel connection of the batteries via a cut-off relay

The battery cut-off (at the battery cut-off switch of the Electrobloc, see Fig.

4, Pos. 15, see also section 3.4) isolates the following connections from the

living area battery:

F all 12 V consumers

F the frost protection valve

This prevents slow discharge of the living area battery by the standby cur-

rent during shutdown of the vehicle (discharge with approx. 4 Ah in month).

The batteries can still be charged using the Electrobloc, the alternator, an

auxiliary charging unit or the solar charge regulator, even when the battery

cut-off switch is switched off.

The switching option provided by the battery selector switch ensures opti-

mum charging of the two battery types, lead gel and lead acid.

The battery monitor of the DT ... control and switch panel constantly moni-

tors the living area battery with dynamic voltage threshold. Lower discharge

currents cut off ”earlier” than with larger currents. This provides improved to-

tal discharge protection. Monitoring is also performed in the switched-off

state. A warning message is displayed below 12.0 V (dependent on current

drain).

If the voltage of the living area battery sinks further, falling below 10.5 V, the

battery monitor immediately switches off all 12 V consumers. The control

and switch panel also switches itself off. Only the frost protection valve con-

tinues to be powered (so it stays closed). Before switch-off, all switch states

and the value of the battery capacity are stored and restored after power-on.

If an overload or an insufficiently charged living area battery causes the vol-

tage to fall so low that the automatic disconnector is triggered, any non-es-

sential consumers should be switched off.

If need be, the 12 V supply can begin operation for a short time. In this case

the 12 V main switch on the DT ... control and switch panel must be swit-

ched on.

However , if the battery voltage remains below 11.0 V, the 12 V power supply

can not be turned back on.

Fully charge the living area battery as soon as possible. For more informa-

tion, see the ”Battery voltages” description in the associated DT ... control

and switch panel instruction manual.

Suitable batteries

Battery charging

during mobile operation

Battery isolation

Battery selector switch

Battery monitor w ith

automatic disconnect

Jag äger en Detleffs husbil med elekronikskåp EBL101. Jag använder ett AGM-batteri till bodelen. Hur skall batteri-väljaren ställas på elektronikskåpet? Bly eller Gel?
Tack! Submitted on 20-10-2021 at 10:11
Reply Report abuse
Hi
Got a electroblock 101 on a Hymer and it doesn't seem to be charging
Also the AES does not work on 12 v could you tell me if there is
A problem with the electroblock
Regards Submitted on 11-9-2021 at 21:26
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Schaudt Elektroblock EBL 101 C in the language / languages: English as an attachment in your email.

The manual is 0,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Schaudt Elektroblock EBL 101 C

Schaudt Elektroblock EBL 101 C User Manual - German - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Schaudt Elektroblock EBL 101 C Manual

Product: