690869
20
Zoom out
Zoom in
Previous page
1/81
Next page
www.schaerer.com Installation and commissioning
BA JDE BARISTA ONE_EN
V01 | 07.2016
20
DANGER!
Risk of electrocution!
Risk of electrocution!
Please adhere to the following points:
The phase must be fused at the ampere value specified on the serial plate.
It must be possible to disconnect the device from the mains power supply at all poles.
The electrical system on the installation site must conform to IEC 364 (DIN VDE 0100). To
increase safety, the device should be connected to an RCD switch with 30 mA nominal er-
ror current (EN 61008). (Type B residual current circuit breakers ensure response even in
the event of smooth DC residual currents. This results in a high level of safety.)
Never operate a device with a damaged power cable. Have a defective power cable or plug
replaced immediately by a qualified service technician.
Schaerer AG recommends against using an extension cable. If an extension cable is used
despite this (minimum cross-section: 1.5 mm²), please comply with the manufacturer’s
specifications for the cable (operating instructions) and with locally applicable regulations.
Route the power cable in such a way that it does not pose a tripping hazard. Do not pull
the cable over corners or sharp edges, pinch it between objects or allow it to hang loosely
in open spaces. Do not position the cable over hot objects, and protect the cable from ex-
posure to oil and aggressive cleaning products.
Never lift or pull the device by the power cable. Never pull the plug out of the socket by its
cable. Never touch the power cable or plug with wet hands. Never insert a wet plug into a
power socket.
Power cable
CAUTION!
User at risk!
Use of a faulty power cable or one that is not the original cable results in the risk of elec-
tric shock and fire.
Use the original power cable.
The original power cable for your country can be obtained from your service partner.
Power cables that are plugged in on both sides can be replaced by the customer.
Permanently connected power cables must be replaced by a service technician.
Power requirements
Barista ONE
Mains Power requirements
Fuse protec-
tion (building
side)
Connecting
cable, conduc-
tor cross-sec-
tion
*1L, N, PE
(CH)
220 – 240 V ~ 50/60 Hz 2000-2400 W 10 – 16 A 3 x 1.0 mm²
1L, N, PE 100 V ~ 50/60 Hz 1350 W 15 A
3x1.5mm²
3 x 16 AWG
1L, N, PE 110 – 120 V ~ 50/60 Hz 1800 W 15 A
3x1.5mm²
3 x 16 AWG
2L, PE 200 V 2~ 50/60 Hz 1800 W 15 A
3x1.5mm²
3 x 16 AWG
2L, PE 220 – 240 V ~ 50/60 Hz 2000-2400 W 10 – 16 A 3 x 1 mm²
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Schaerer JDE Barista ONE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Schaerer JDE Barista ONE in the language / languages: English as an attachment in your email.

The manual is 2,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Schaerer JDE Barista ONE

Schaerer JDE Barista ONE User Manual - Dutch - pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info