50 Parametrierung SATEL
4.3.2 Programmieren der Abschlusswiderstandswerte
Bei einigen Meldelinien auf der Hauptplatine der Zentrale, einigen Bedienteilen und
Erweiterungsmodulen können Sie für die Abschlusswiderstände einen Wert aus dem Bereich
von 500 bis 15 k einstellen (die Gesamtsumme eingestellter Werte darf nicht 15 k
überschreiten).
Der Abschlusswiderstandswert für Linien auf der Hauptplatine wird wie folgt programmiert:
im Servicemodus im Bedienteil mit Hilfe der Funktion ABSCHL.WIDERST.R1,
ABSCHL.WIDERST.R2 und ABSCHL.WIDERST.R3 (STRUKTUR MODULE
ABSCHL.WIDERST.R1/ ABSCHL.WIDERST.R2/ ABSCHL.WIDERST.R3);
im Programm DLOADX im Fenster „Struktur“, in der Registerkarte „Module“ nach
dem Klicken auf die Hauptplatine der Zentrale.
Der für die Linien auf der Hauptplatine eingestellte Abschlusswiderstandswert bezieht
sich auch auf die Linien im Bedienteil:
INT-KLCD und INT-KLCDR mit der Elektronikversion 3.2 und der Firmwareversion
2.11 (oder höher),
INT-KLFR,
INT-KSG mit der Firmwareversion 1.02 (oder höher),
INT-TSG,
INT-TSH,
INT-TSI.
Der Abschlusswiderstandswert für Linien in Erweiterungsmodulen kann wie folgt
programmiert werden:
im Servicemodus im Bedienteil mit Hilfe der Funktion ABSCHL.WIDERST.R1,
ABSCHL.WIDERST.R2 und ABSCHL.WIDERST.R3 (STRUKTUR MODULE ERW.MODULE
EINSTELLUNGEN [Name des Erweiterungsmoduls] ABSCHL.WIDERST.R1 /
ABSCHL.WIDERST.R2 / ABSCHL.WIDERST.R3);
im Programm DLOADX im Fenster „Struktur“, in der Registerkarte „Module“ nach
dem Klicken auf das gewünschte Erweiterungsmodul.
Für die Linien im Bedienteil INT-KSG mit der Firmware 1.00 oder 1.01 definiert man den Wert
der Abschlusswiderstände im Programm DLOADX im Fenster „Struktur“, in der Registerkarte
„Module“ – klicken Sie auf das Bedienteil und wählen Sie die entsprechende Registerkarte
aus. Die Widerstandswerte können nicht über das Bedienteil programmiert werden.
Die empfohlene Firmwareversion des Bedienteils INT-KSG ist 1.02 (oder höher).
Abb. 4. Nummerierung der Abschlusswiderstände. T – Sabotage. A – Alarm. M – Abdeckung.
Bei den Konfigurationen EOL und 2EOL hat der Wert des Widerstandes R3 keine