699577
22
Zoom out
Zoom in
Previous page
1/43
Next page
20 Installer Manual SATEL
The LCD keypads can only interface in the alarm system with the expander version
manufactured since February 1998.
The expander address should be programmed as the address of consecutive keypads:
second, third and fourth – if the expander is connected to CLK2;
third and fourth – if the expander is connected to CLK3;
fourth – if the expander is connected to CLK4.
Connection of detectors
The CA-10 can operate with any type of detectors. Each zone of the control panel can work
in the configuration:
NC (normally closed),
NO (normally open),
EOL (End Of Line Resistors),
2EOL/NO (Double End Of Line Resistors, NO type detector),
2EOL/NC (Double End Of Line Resistors, NC type detector).
When the zone works in a EOL configuration, a 2.2 k resistor should be used to make the
detector circuit. With 2EOL zone, the detector circuit is closed by two 1.1 k resistors.
The zones of 2EOL type enable the status of detector and its tamper contact to be monitored
at the same time (see: Fig. 9).
The detectors may be power supplied from any of the electronically protected outputs (OUT1
to OUT4). The output should be programmed as the "POWER SUPPLY OUTPUT". Detectors
connected to the keypad zones can be power supplied from the +KPD output.
NC
NC TMP COM
12V
NC TMP
CA-10
COM COM
Z2
Z3
Z4
Z5
Z1 COM
Fig. 8. Example of connecting NC type detector to control panel (NO type detector is to be
connected in the same way).
supply
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel CA-10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel CA-10 in the language / languages: English as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel CA-10

Satel CA-10 User Manual - English - 2 pages

Satel CA-10 User Manual - English - 2 pages

Satel CA-10 User Manual - English - 2 pages

Satel CA-10 Additional guide - English - 60 pages

Satel CA-10 Additional guide - English - 24 pages

Satel CA-10 User Manual - English - 24 pages

Satel CA-10 Quick start guide - English - 11 pages

Satel CA-10 User Manual - German - 2 pages

Satel CA-10 User Manual - German - 4 pages

Satel CA-10 Additional guide - German - 64 pages

Satel CA-10 Additional guide - German - 24 pages

Satel CA-10 User Manual - German - 26 pages

Satel CA-10 Installation Guide - German - 44 pages

Satel CA-10 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info