699764
5
Zoom out
Zoom in
Previous page
1/9
Next page
SATEL ASD-200 3
Test mode
The test mode makes diagnostics of the detector easier, because the detector LED indicates
periodical communication and alarm memory. How to start and end the test mode is
described in the ABAX 2 / ABAX controller manual / the INTEGRA 128-WRL control panel
manual.
The alarm memory is cleared after ending the test mode.
LED
LED indicates:
low battery – 3 short flashes every 30 seconds,
alarm – ON for 5 minutes.
When the ABAX 2 / ABAX system is running in the test mode, the LED indicates additionally:
periodical communication – short flash (80 milliseconds), and when the chamber is soiled
- 2 short flashes,
memory of alarm triggered by smoke sensor – flashing rapidly,
memory of alarm triggered by heat sensor – flashing slowly.
Energy saving mode (ECO)
If you want to prolong the battery life, you can enable in the detector the “ECO” option. When
the “ECO” option is enabled, the periodical communication takes place every 3 minutes. Thus
the battery life can be increased as much as fourfold. The option is only available in the
ABAX 2 system.
Detection of optical chamber soiling
The detector is monitoring the state of the optical chamber. Deposition of dust in it may lead
to malfunctioning of the device. When the optical chamber requires cleaning, this state is
indicated by the LED.
Battery status control
When the battery voltage is lower than 2.75 V, the detector indicates low battery: 3 short
flashes of LED and 3 short beeps every 30 seconds. The low battery info is sent during each
transmission to the controller / control panel.
3 Selecting a mounting location
The detector is designed for indoor installation.
The detector should be installed in location close to the building / apartment exit (e.g. in
the hall, lobby etc. – Fig. 2 and Fig. 3).
In the typical home or office applications, the detector should be installed on the ceiling,
as close as possible to the center of the room, at a distance of at least 0.5 meters from
the walls or other objects (Fig. 4).
Do not install the detector in places with high concentration of dust and/or formation and
condensation of water steam.
Do not install the detector near heaters, cookers, fans or air-conditioner outlets.
Do not install the detector in places where there is no unobstructed movement of air (e.g.
in recesses, niches, etc.).
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel ASD-200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel ASD-200 in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel ASD-200

Satel ASD-200 User Manual - German - 10 pages

Satel ASD-200 User Manual - Dutch - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info