699622
5
Zoom out
Zoom in
Previous page
1/6
Next page
SATEL ACX-220 3
C1...C4 - relay output common contact.
NC1...NC4 - relay output normally closed contact.
NO1...NO4 - relay output normally open contact.
4. Installation
Disconnect power before making any electrical connections.
The ACX-220 expander should be installed indoors, in spaces with normal air humidity.
Remember that thick walls, metal partitions, etc. will reduce the range of the radio signal. It is
recommended that the expander be mounted high above the floor. This will allow you to get
a better range of radio communication and avoid the risk of the expander being accidentally
covered by people moving around the premises. Installing the device in close vicinity of
electrical systems is not recommended, since it can adversely affect the range of radio
signal.
The expansion module can be supplied from a power supply unit connected to the APS
connector (e.g. from the APS-412 power supply offered by SATEL) or, alternatively, from the
+12V and COM terminals. In the latter case, the control panel, expander with power supply,
or power supply with a 3 A current limiter can serve as a power source.
If a power supply unit is connected to the APS connector, the expander will send
information about the following power supply unit troubles:
- loss of 230 V AC mains,
- low battery,
- power supply overload.
1. Loosen the screws locking the enclosure cover and remove the cover.
2. Connect the temporary 12 V DC power supply to the expander.
3. Add the expander to the wireless system (see the ABAX 2 / ABAX controller manual or
the INTEGRA 128-WRL control panel installer manual). The sticker with serial number
which shall be entered when registering the expander in the system can be found on the
electronics board.
In the INTEGRA / VERSA alarm system, the expander is identified as ACX-201.
Simultaneous operation of the expander by the ABAX 2 and ABAX controller /
INTEGRA 128-WRL alarm control panel is not possible.
4. Place the expander in the location intended for its installation.
5. Check the level of signal received from the expander by the ABAX 2 / ABAX controller or
the INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select
another place for installation. Sometimes, it is sufficient to shift the device ten or twenty
centimeters to obtain a considerable improvement in the signal quality.
The ARF-200 tester makes it possible to check the radio signal strength at the place of
future installation without having to put the expander there.
6. Disconnect the temporary 12 V DC power supply.
7. Make a hole for the bunch of wires in the enclosure base.
8. Run the wires through the hole (power cables, cables connecting wired devices with the
expander, etc.).
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel ACX-220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel ACX-220 in the language / languages: English as an attachment in your email.

The manual is 0,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel ACX-220

Satel ACX-220 Quick start guide - English - 2 pages

Satel ACX-220 User Manual - German - 6 pages

Satel ACX-220 Quick start guide - German - 2 pages

Satel ACX-220 User Manual - Dutch - 6 pages

Satel ACX-220 Quick start guide - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info