783738
18
Zoom out
Zoom in
Previous page
1/18
Next page
Abtauung beendet ist, wird die normale Anzeige nach 20 Minuten der
Raumtemperaturanzeige (oder niedriger als die eingestellte Temperatur)
wieder aufgenommen. Die LED-Beleuchtung blinkt während des
Verzögerungsvorgangs.
4. Anormaler Arbeitsmodus:
Wenn der Sensor kurzgeschlossen oder überhitzt ist (mehr als 99℃),
wird " HH" angezeigt. Wenn der Sensor
bei offenem Stromkreis oder zu niedriger Temperatur (weniger als-
45℃), wird " LL" angezeigt. In diesem Fall wird der Kompressor
automatisch in den Zeitsteuerungs-Betriebsmodus durch den Zyklus von
30 Minuten ein und 15 Minuten aus.
5. Schaltplan
Installation
1. Sensorleitungen müssen von Hauptspannungsleitungen
getrennt gehalten werden, um hochfrequentes Rauschen zu vermeiden.
Trennen Sie die Stromversorgung der Sensoren von der
Stromversorgung des Controllers.
2. Bei der Installation ist der Sensor mit dem Kopf nach oben
und dem Draht nach unten zu platzieren.
3. Bei der Installation der Sonde über große Entfernungen vom
Regler kann das Sondenkabel ohne Neukalibrierung bis max. 100 m
verlängert werden.
4. Der Temperaturregler kann nicht in dem Bereich mit
tropfendem Wasser installiert werden.
Zubehör für den Temperaturregler
1. Ein Temperaturfühler 2. Ein Montageständer
4. Abnormal work mode:
When sensor is short-circuited or overheated (more than 99℃),
"HH" is displayed. When sensor is open-circuited or temperature
is too low (less than45℃/-49℉), " LL" is displayed. At that
time the compressor automatically enters timing operation mode
by the cycle of 30 minutes on and 15 minutes off.
5. Circuit Diagram:
Notes for Installation
1. Sensor leads must be kept separately from main voltage
wires in order to avoid high frequency noise induced. Separate
the power supply of the loads from the power supply of the
controller.
2. When installation the sensor shall be placed with the head
upward and the wire downward.
3. In case of long-distance probe installation from the
controller, the probe cable may be prolonged up to 100 m max.
without any re-calibration
4. The temperature controller can not be installed in the area
with water drops.
Accessories for the temperature controller
1. One temperature sensor
2. One installation stand
Parameter
Function Set range De
fault
F1
Max. Defrost
duration
0190Min 20Min
F2
Defrost interval
time
0024Hr 0Hr
F4
Display during
defrost
00= normal display
01= last value before
defrost
01
Parameter
Funktion
Einstellbereich
Standard
F1
Max.
Abtauung
Dauer
01
90 Min
20Min
F2
Abtauung
Intervall Zeit
00
24 St.
0 St.
F4
Anzeige während
Abtauung
00 = normale
Anzeige
01 =
letzter
Wert vor
Abtauung
01
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saro G885 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saro G885 in the language / languages: English, German as an attachment in your email.

The manual is 1.77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info