37
SETTING
This function turns the Projection Lamp off when this projector
detects signal interruption and is not used for a certain period in
order to reduce power consumption and maintain the Lamp-life.
(This projector is shipped with this function ON.)
The Power Management function operates to turn the Projection
Lamp off when the input signal is interrupted and any button is not
pressed over 5 minutes. This function operates as follows;
1. When any input signal is interrupted, “No signal” and the
counting down display appears (for 5 minutes).
2. After counting down for 5 minutes, the Projection Lamp and the
READY Indicator are turned off. (Cooling Fans keep running.)
3. The READY Indicator starts to flash after cooling down the
Projection Lamp about for 90 seconds (Power Management
mode).
In this Power Management mode, the Projection Lamp is
automatically turned on when the input signal is connected or
the projector is operated with any button on the Top Control or
on the Remote Control again.
Power management
This function is used to reset the Lamp Replace Counter. When
replacing the Projection Lamp, reset the Lamp Replace Counter by
using this function. Refer to page 38 for operation.
Lamp counter reset
Remote control
This projector has eight different remote control codes (Code 1-Code
8); the factory-set, initial code (Code 1) and the other seven codes
(Code 2 to Code 8). This switching function prevents remote control
operation mixture (jam) when operating several projectors or video
equipment together.
For example operating the projector in “Code 7,” both the projector
and the Remote Control must be switched to “Code 7.”
To change the code of the Projector;
To change the remote control code of the projector used in ON-
SCREEN MENU is selectable from Code 1 to Code 8.
To change the code of the Remote Control;
To change the remote control code of the Remote Control, set the
DIP switches 1-3 inside the battery compartment box of the Remote
Control. (Refer to page 14.)
On start
When this function is “On,” the projector is automatically turned on
just by connecting the AC Power cord to a wall outlet.
Note ; Be sure to turn the projector off properly (refer to the section
“TURNING OFF PROJECTOR” on page 19). If the projector
is turned off in the wrong steps, the On Start function does not
operate properly.
Time left until Lamp off.
Move the pointer to the item
and then press the POINT
LEFT/RIGHT button(s).
Press the SELECT button at this
icon to display other items.
Press the SELECT button at
this icon to display previous
items.
When pressing the SELECT button
at Remote control, the Remote
control code menu appears.
