797030

Sangean WFR-32 Manual

6
Zoom out
Zoom in
Previous page
1/19
Next page
05
GB
●Go to next track in Media Center / Bluetooth / USB
mode
o Pairing button
●Switch to Bluetooth pairing mode
p Down button
●Select menu item
●Select character
q Sleep timer button
●Set the sleep timer
r Right button
●Select menu item
●Go to next menu
●Input character and go to next character or move
cursor to next character
s Enter button
●Conrm selection
●Conrm text input
t Fav.+ button
●Open favorites list
u Volume up / down buttons
●Raise / lower the volume
v Home button
●Go back to Main menu
3. BEFORE USING THE RADIO
FINDING A SUITABLE LOCATION FOR THE
RADIO
After unpacking the radio from the box, take the following
guidelines into account when finding a suitable location
for the radio:
●Place the radio on a at, even surface such as a table.
●Do not place the radio near heat sources.
●Make sure there is sufcient space available around the
radio for proper ventilation.
●If you are planning to connect the radio to your Wi-
Fi network, make sure to place the radio in a location
where Wi-Fi reception is good.
●Avoid placing the radio near appliances that can
interfere with Wi-Fi reception, such as microwaves.
INSTALLING BATTERIES IN THE REMOTE
CONTROL
The radio’s remote control requires two AAA batteries (not
included) to operate. To place the batteries:
1. Open the battery compartment on the back of the
remote control.
2. Insert two AAA batteries in the battery compartment with
polarities as shown in the diagram inside the battery
compartment.
3. Close the battery compartment again.
NAVIGATION AND TEXT INPUT
Before connecting the radio to the power supply and
configuring the radio, it is important to understand how to
navigate menus on the radio and how to input text in order
to ensure the radio can be set up and used smoothly.
NAVIGATING THE RADIO MENUS
The radio’s menus can be navigated using either a
combination of the Volume control (4) and Previous
(5) and Next (6) buttons on the radio itself or the arrow
buttons (d, e, p, and r) and Enter button (s) on the remote
control.
In horizontally displayed menus (such as the menus
that are displayed during the setup wizard and the main
menu), an item or submenu can be highlighted by either
rotating the Volume control (4) or pressing the Previous (5)
and Next (6) buttons on the radio or using the Left (e) and
Right (r) buttons on the remote and then pressing either
the Volume control (4) on the radio or the Enter button (s)
on the remote to confirm.
In vertically displayed menus (most other menus), the
Volume control (4) on the radio and Up (d) and Down (p)
buttons on the remote can be used to highlight an item,
while pressing the Volume control (4) on the radio or the
Enter button (s) on the remote can be used to confirm
your choice. The Previous button (5) on the radio and the
Left button (e) on the remote can now be used to go back
to the previous menu and the Next button (6) and Right
button (r) can be used to go to the next menu.
ENTERING CHARACTERS
In some cases, you will have to input characters on
the radio, for instance when connecting to a password
protected Wi-Fi network or when entering the date and
time. In this case, both the buttons on the radio and the
buttons on the remote control can be used as well.
When using the buttons on the radio, rotate the Volume
control (4) to select the desired character and when
it is displayed, press the Next button (6) to go to the
next character. The Previous button (5) can be used to
move the cursor back one step and delete the selected
character, while pressing the Volume control (3) confirms
the input.
When using the remote, characters can be input in the
same way, using the Up (d) and Down (p) buttons to
select the character, while the Left (e) and Right (r) are
used to go to previous or next character. The remote also
offers a faster alternative for inputting characters using
the numeric buttons (c), however. The table below shows
which numeric button corresponds to which characters.
Cycle through the characters by repeatedly pressing a
button. Confirm input by pressing the Enter button (s).
1 Special characters (@, !, ", etc.)
2 A B C a b c
3 D E F d e f
4 G H I g h i
5 J K L j k l
6 M N O m n o
7 P Q R S p q R s
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sangean WFR-32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sangean WFR-32 in the language / languages: English as an attachment in your email.

The manual is 2.01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sangean WFR-32

Sangean WFR-32 User Manual - German - 20 pages

Sangean WFR-32 User Manual - Dutch - 20 pages

Sangean WFR-32 User Manual - French - 21 pages

Sangean WFR-32 User Manual - Spanish - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info