797387
6
Zoom out
Zoom in
Previous page
1/16
Next page
GB
F
E
NL
D
05
Powered via DC IN socket
The radio can be also powered via the DC IN socket
which can allow 12 Volt DC, which is designed to be
powered by the vehicle or the boat so you can take the
radio with you outdoors or on the boat.
An additional cigarette lighter cable is required (not
supplied) for this device.
NOTE
Never use the 12 Volt socket in rainy or moist conditions
to prevent moist from entering the radio. Always keep
the rubber cover on the back well closed under these
conditions.
NOTE
If no controls are used and no sound output from the
radio for 15 minutes, the radio will be put into standby
mode when using the mains power. When the radio is
operated on battery power, the radio will be switched off
completely in order to minimize battery usage.
Battery charging status indicator
Please note that the battery charging status detection
can only be activated when the radio is in charging mode
(i.e. the radio is switched off, the battery switch slides to
the NiHM position and it is connected to the AC mains
socket).
1. When charging is in progress,
display is shown at right and the
charging indicator ashes yellow.
2. When the charging process is
completed, the charging indicator
lights in steady yellow.
If batteries are already fully charged, display is
shown at right and it will switch to standby mode after 5
seconds.
3. When there is no battery / missing
batteries in the compartment or
some of batteries are inserted
with the incorrect polarity, display is shown at right
and it will enter standby screen after 5 seconds.
NOTE
If a battery is removed while charging, display is
shown at right and the charging indicator lights red.
4. During the charging process, if a
battery is detected as faulty /
damaged, a solid square will be
displayed under the corresponding battery number (see
picture, right) and the charging indicator ashes red.
UsingDABforthersttimeDAB
1. Straighten up the antenna.
2. Press the Power button to switch on the radio. If the radio
has been used before the last used mode will be selected.
3. Press and release the Source button to select DAB
mode. The display will show DAB for a few seconds.
4. If this is the first time the radio is used a quick scan
of the DAB Band III channels may be carried out. The
display will show ‘Scanning’ (If the radio has been
used before the last used station will be selected
instead.) During the scanning process, as new stations
are detected the station counter will increase and the
stations will be added to the list which is stored in the
radio. The bar graph indicates the progress of the scan.
5. When scanning is completed the radio will list the
stations found (in numeric-alpha order 0....9...A...Z),
unless it has previously been tuned to a DAB station.
Rotate the Tuning control to scroll through the list of
available DAB radio stations. Press the Tuning control
to select the highlighted station. When a DAB station
is found, the display will show the station name on the
upper line of the text display and broadcast information
on the lower line. Use the Volume control to set the
sound level as needed.
6. If the station list is still empty after the scan the display
will show ‘No DAB Station’ then return to the DAB
menu. If no stations are found it may be necessary to
relocate your radio to a position giving better reception.
Selectingastation–DAB
1. When playing a DAB radio station, the display normally
shows the name of the current station with other related
information.
2. Rotate the Tuning control to access the radio station
list and scroll through the available stations.
3. Press the Tuning control to select the desired station.
4. Use the Volume control to set the sound level as needed.
If the display shows 'Service Not Available' it may be
necessary to relocate your radio to a position giving
better reception.
A question-mark in front of the station name merely
indicates that the station has not recently been detected
by the radio. It may still be available.
NOTE
Secondaryservices–DAB
1. Certain radio stations may have one or more secondary
services associated with them. If a station has a
secondary service associated with it the display will
show “>>” next to the station name on the station list.
The secondary service will then appear immediately
after the primary service as you rotate the Tuning
control.
2. Press and release the Tuning control to select the
station. Most secondary services do not broadcast
continually and if the selected service is not available,
the radio will re-tune to the associated primary service.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sangean U4D BT plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sangean U4D BT plus in the language / languages: English as an attachment in your email.

The manual is 2.4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sangean U4D BT plus

Sangean U4D BT plus User Manual - German - 18 pages

Sangean U4D BT plus User Manual - Dutch - 17 pages

Sangean U4D BT plus User Manual - French - 18 pages

Sangean U4D BT plus User Manual - Spanish - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info