797015
7
Zoom out
Zoom in
Previous page
1/12
Next page
6
Using the radio for the rst time
Using the AC power adaptor
The AC power adaptor required for this unit should be 7.5 volts DC at 0.8A center pin positive.
Insert the adaptor plug into the DC socket on the rear of the radio.
Plug the adaptor into a standard electrical outlet.
The AC adaptor should be disconnected from the main power supply when not in use.
IMPORTANT:
The AC Adapter is used as the means of connecting the radio to the power supply. The AC Adapter
used for this radio must remain accessible during normal use. In order to disconnect the radio from
the power supply completely, the AC Adapter should be removed from the power supply outlet
completely.
Backup battery operation (Only available to customers purchased in North America)
1. Remove the battery cover on the bottom of the unit.
2. Insert two UM-3 (AA size) batteries into the spaces in the compartment.
3. Take care to ensure all batteries are inserted with correct polarity as shown inside the compartment.
Replace the battery cover.
4. When the radio is used as a clock radio or as an alarm, please always keep the batteries inserted.
Note:
Batteries will only back up preset memories and clock functions during power outage and is not
intended for normal radio operation.
Setting the clock
You can set the clock with either the radio turned on or off.
After the radio is plugged in properly the display will appear with (- : --). Press the Clock set button,
then you will hear a beep and the hour digit starts ashing, select the hour by pressing the Tuning up/
down button until desired hour is displayed. Press the Clock set button again to set the minutes. The
minute digit should now be ashing, press the Tuning up/ down button until the desired minutes are
displayed. Press the Clock set button again to complete clock setting. The time should display solidly
with the colon ashing periodically.
Radio operation- Manual tuning AM/FM
1. Fully extend the FM wire antenna located on the rear of your clock radio. Place the wire antenna
so that it is as straight as possible extending either above or below the radio.
2. Press the Standby button to turn on your radio.
3. Press the Source button repeatedly to select AM (MW) or FM 1 or 2 frequency band.
4. Press the Tuning up/ down button to change the frequency.
5. To see the time or frequency on the screen, press the Display button
Note:
When your radio has any interference in AM band by its adaptor, please move your radio away from
its AC adaptor over 30 cm.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sangean RCR-24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sangean RCR-24 in the language / languages: English as an attachment in your email.

The manual is 0.96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sangean RCR-24

Sangean RCR-24 User Manual - German - 12 pages

Sangean RCR-24 User Manual - Dutch - 12 pages

Sangean RCR-24 User Manual - French - 12 pages

Sangean RCR-24 User Manual - Spanish - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info