528624
10
Zoom out
Zoom in
Previous page
1/33
Next page
9
Presetting AM/FM Stations
You may store up to 5 station presets for each FM/AM band. Using the
preset buttons saves your time when searching your favorite stations.
1. Press the STANDBY button to turn the radio function on, then tune to
your desired station.
2. Press and hold the required PRESET button (1 to 5) for 2 seconds
until there is a beep sound, and the display shows “PRESET 1”.
The station will be stored using the chosen preset number.
Repeat this procedure for the remaining presets as you wish
3. Preset memories which have already been stored may be overwritten
by following the above procedure if required.
Recalling a Preset AM/FM Station
1. Press the STANDBY button to turn the radio function on.
2. Select the desired waveband by pressing the BAND button.
3. Momentarily press the required PRESET button (1 to 5) to tune your
radio to the station stored in preset memory.
Selecting the Weather Band Channel
To receive alerts, you must first select the correct weather channel.
NOAA broadcasts on the weather band on seven channels in
25kHz increments, between the frequencies of 162.400MHz
and 162.550MHz.
To identify the appropriate channel for your area, visit the NOAA
website at: http://www.nws.noaa.gov/nwr/indexnw.htm
The table on the NOAA website includes the correct weather band
channel for your area, the SAME code and the location of the
broadcast tower. Look for the state in which you live and then search
the list for your county. Use the channel listed for your county when
programming the radio.
10


Need help? Post your question in this forum.

Forumrules
1

Forum

sangean-cl-100

Reset search

  • I love my Sangean CL-100 but have an issue with it and the manual. I cannot figure out how to preset the audio volume. The Alert volume level is just fine, but when an alert comes in and we are in another part of the house we have to run to the radio and turn up the voice volume to hear what the alert is all about. After the alert is over, the volume defaults back to it's lower preset level. Is there a way to preset the audio volume so I can avoid having to manually raise it for each alert? Submitted on 25-4-2023 at 01:57

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sangean CL-100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sangean CL-100 in the language / languages: English as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info