630074
6
Zoom out
Zoom in
Previous page
1/45
Next page
6
Guided Tour - VM1
9: DC input - This jack will accept a DC
input voltage of 11 - 14 volts (inner
connection [tip] positive, outer connection
[sleeve] ground) from your video camera, if
available. Connect the optional Samson
AC300R adapter here to charge a
rechargeable 9-volt Ni-Cad battery.
10: Unbalanced output - Use this unbalanced 1/8" (3.5 mm) mini-phone jack to connect
the VM1 to your audio equipment. Wiring is as follows: tip hot, sleeve ground. If your
video camera has stereo audio inputs, youll need to use a Y-adapter that has a 1/8"
(3.5 mm) mini-phone plug at one end and dual male RCA-type plugs at the other end.
11: Audio Output Level switch - Sets the audio output level of the unbalanced output
(see #10 above) to -30 dBv (mic level), -20 dBv, or -10 dBv (line level). See the Setting
Up and Using the VM1 System section on page 8 in this manual for more information.
12: Level control - This knob sets the level of the audio signal being sent to the
headphones output (see #13 below).
13: Headphones output - Connect a
stereo headphone to this standard 1/8"
(3.5 mm) mini-phone jack in order to monitor
the signal being output by the VM1.
We recommend the use of 30 ohm
headphones. The level of the headphone
signal can be set by adjusting the Level control (see #12 above). Maximum output is
200 mW @ 30 ohms.
14: Meter switch - This three-position switch determines the function of the front-panel
VM1 meter (see page #2 on previous page). In the left BATTERYposition, the meter
indicates relative battery power, showing whether the installed battery is at low (red), mid
(yellow) or high (green) strength. When all three LEDs are lit, the battery is at maximum
strength. When only the red low indicator lights, performance is degraded and the battery
needs to be replaced. In the center RF position, the meter indicates the strength of the
incoming RF signal. In the right OFFposition, the meter is disabled altogether, thus
conserving battery power.
VM1 Frequency Conversion Chart
Channel Frequency
9 199.6 MHz
11 208.2 MHz
17 174.1 MHz
18 174.5 MHz
20 177.0 MHz
25 197.4 MHz
ENGLISH
-30-20-10
LEVEL
OUTPUT
DC INPUT
109 118
METER
RF
12
13
14
BATT.
P
H
O
N
E
S
L
E
V
E
L
SAMSON
VM1
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson VHF Micro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson VHF Micro in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info