Manual Samson VHF Micro (page 5 of 45) (English, German, French, Spanish)

630074

Zoom out

Zoom in

1/45

Guided Tour - VM1

1: A/B Antenna LEDs - When signal is

being received, one of these will be lit

orange, showing you whether the (left) “A” or

(right) “B” antenna is currently being used.

The VM1 constantly scans its two antennas

and automatically selects whichever is receiv-

ing the strongest, clearest signal. This

True

Diversity switching is completely inaudible,

but it effectively increases overall range while

virtually eliminating potential interference and

phase cancellation problems.

2: Meter - This set of three multicolor LEDs

acts as a meter, indicating either battery

power or the strength of the incoming RF

signal. This meter can also be disabled

altogether to conserve battery power. See

#14 on the next page for more information.

3: Peak LED - This LED lights red when

output signal from the VM1 is at the onset of

clipping (that is, when it is on the verge of

being distorted). If you see this light during

operation, move the microphone further away

or lower the output level of your instrument or

transmitter. For more information, see the

section entitled “Setting Up and Using the

VM1 System” on page 8 in this manual.

4: Power switch - Use this to turn the VM1

power on and off.

5: SQ (Squelch) Level control - This

control determines the maximum range of the

VM1 before audio signal dropout. Although it

can be adjusted using the supplied plastic

screwdriver, it should normally be left at its

factory setting. See the “Setting Up and

Using the VM1 System” section on page 8 in

this manual for more information.

6: Battery holder - Insert a standard 9-volt alkaline battery here, being sure to observe

the plus and minus polarity markings shown. We recommend the Duracell MN 1604 type

battery. Although rechargeable Ni-Cad batteries can be used, they do not supply adequate

current for more than two hours. WARNING: Do not insert the battery backwards; doing

so can cause severe damage to the VM1 and will void your warranty.

7: Plastic screwdriver - Specially designed for use in adjusting the VM1 Squelch Level

control (see #4 above). See the “Setting Up and Using the VM1 System” section on page

8 in this manual for more information.

8: Antennas (A and B) - The antenna mountings allow full rotation for optimum

placement. In normal operation, both antennas should be placed in a vertical position.

Both antennas can be folded inward for convenience when transporting the VM1. See the

“Setting Up and Using the VM1” section on page 8 in this manual for more information.

ENGLISH

SAMSON

MAX

MIN

POWER

SQ LEVEL

VHF MICRO DIVERSITY RECEIVER

LOW MID HIGH PEAK

2 3 1

VM1

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Samson VHF Micro in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,25 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Samson VHF Micro Manual

Product: