629661

Samson S-Zone Manual

14
Zoom out
Zoom in
Previous page
1/108
Next page
Next connect your line inputs to channels 1 and 2 using
the wiring guide below.
These inputs are set to accept –10 dBV levels, which is the
standard for devices like most CD and DVD players.
Now connect your line inputs to channels 3 and 4 using
the wiring guide below.
These inputs are set to accept –10 dBV levels, which is the
standard for devices like most CD and DVD players.
Get Connected !
The S zone’s rear panel is where you will find all (except the
headphone jack) of the input and output connections. The
S zone provides four input channels that can accept up
to four line level sources and two microphones and four
output channels to feed the sound zones. The connections
for these inputs and outputs are made via standard Eurob-
lock connectors (the mating ends to connect to your wires
have been included). The Euroblock connectors are easy
to wire-up; just strip your wire, insert it into the Euroblock
connector and tighten down the screws. The next section
of this manual will detail the connections for the S zone’s
inputs and outputs.
Connecting the S zone Inputs
After you have designed a plan for your installation you
will need to connect your audio sources to the S zone’s
inputs. You may want to connect several devices like
microphones for paging, and other line level devices like
CD, DVD, MP3, TAPE or Karaoke players or perhaps a radio
tuner. Regardless of the sound source, it’s important to
connect the inputs properly. Follow the section and wiring
diagrams below to connect your input sources.
The microphone inputs accept low impedance (100 to 600
ohms) balanced or unbalanced microphones.
Connect your microphones to inputs channel 1 and 2 us-
ing the following wiring guide.
Note: The S zone always provides 15 volts of phantom
power to the microphone inputs so you’ll have no problem
using just about any condenser microphone. Dynamic
microphones can be connected as well.
Connecting the S zone
Euroblock Connector
Line Input Wiring for Channel 3 and 4
Line Input Wiring for Channel 1 and 2
Mic Input Wiring for Channel 1 and 2
ENGLISH
10
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson S-Zone at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson S-Zone in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 11,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info