629784
12
Zoom out
Zoom in
Previous page
1/16
Next page
10
Setting up your PS10, PB10, or PB10Pro is a simple procedure which takes only a few
minutes:
1. Remove all packing materials (save them in case of need for future service) and
install the unit in a standard 19” rack. We recommend that the PB10 and PB10Pro
be placed in the top slot so that its slide-out LED lamps can be used to illuminate
the entire rack of equipment below.
2. Connect the PS10, PB10, or PB10Pro to any standard grounded AC outlet. If you
are using a PB10Pro, the front-panel voltmeter and ammeter will show you the
incoming electrical voltage and current draw of connected equipment.
3. Connect the AC cables of your rack equipment to the rear-panel switched AC
outlets, using the included IEC cables.
4. Make sure all connected equipment is switched off, then press the front panel
Outlets switch so that its status light is lit red. This activates all rear panel
switched outlets.
5. Turn on all connected equipment, one at a time. If the total load exceeds 10
amps, the front-panel circuit breaker will trip. To reset it, unplug one or more
devices, then press in the front panel circuit breaker.
6. You can also use the unswitched front panel convenience outlet for additional
temporary power needs (such as connecting a guitar amplifier, soldering iron,
etc.). This outlet is fully operational whenever the PS10, PB10, or PB10Pro is
plugged into an AC source, regardless of the position of the front panel Outlets
switch. The front panel circuit breaker affects this outlet as well as all rear-panel
switched outlets.
7. (PB10 and PB10Pro only) - To illuminate the equipment in your rack, gently pull
the front-panel slide-out cylinders out towards you. The lamps will switch on
automatically .
8. You can illuminate the back of your rack by connecting the included USB
gooseneck LED light to the rear panel USB power socket.
Setting Up and Using Your PowerStrip or PowerBrite
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson PB10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson PB10 in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info