629784
10
Zoom out
Zoom in
Previous page
1/16
Next page
8
PB10PRO Guided Tour - Front Panel
1 4 65 32 3 7 8
PowerBrite PB10Pro Front Panel
1: Circuit breaker- This circuit breaker will trip whenever the total load on the
PB10Pro (all rear panel switched outlets plus the front-panel unswitched
convenience outlet) exceeds 10 amps. To reset it, unplug one or more devices so
as to reduce the load and gently press the circuit breaker in until you hear it click.
Note: It may take a minute to cool before you can reset it.
2: Dimmer -
Use this to adjust the level of the LED light in the slide out Lamps.
3: Lamps- Contains the PB10Pros 5-LED light. Use the Dimmer control (see #2
above) to turn the light on or off. To turn off the lamp, gently slide the lamp back
in.
4: Voltmeter-
This three digit LED meter shows the amount of voltage in the
electrical signal being received by the PowerBrite PB10Pro.
WARNING: Severe voltage swings can cause damage to connected
equipment. If you see the voltmeter changing drastically or rapidly,
disconnect the PB10Pro until the source of the problem is identified.
5: Vents- Convection cooling is accomplished by the front panel vent holes.
6: Ammeter-
This three digit LED meter shows the amount of current being drawn
by equipment connected to the PB PB10Pro.
WARNING: Severe current swings can cause damage to connected
equipment. If you see the ammeter changing drastically or rapidly,
disconnect the PB10Pro until the source of the problem is identified and
repaired.
7: Unswitched convenience outlet- This IEC outlet is active whenever the PB10Pro
is plugged in, regardless of the setting of the Outlets switch (see #8 below).
8: Outlets switch-
Use this to turn the rear-panel outlets on or off. When on, the
status light inside this switch is lit red.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson PB10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson PB10 in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info