24759
12
Zoom out
Zoom in
Previous page
1/76
Next page
10
ENGLISH
Line Level Input - Mono Input Channels
Use these inputs to connect synthesizers, drum machines, effects processors or any line-level signal. The LINE
inputs have a nominal operating level of -40dB through - 10dB. TRS phone jacks (located in the center of the
Combination connector). Connector pin-out - Sleeve: Ground, Tip: Hot (+), Ring: Cold (-)
Microphone Input - Mono Input Channels
Use these inputs to connect Low Impedance microphones and low level signals from direct boxes. The MIC inputs
have a nominal operating level of –50dB through -20dB. The MIC inputs also feature +48V phantom power, allow
-
ing you to use condenser microphones. The Phantom Power switch located on the MDR6’s rear panel enables
phantom power on all the microphone inputs when set to the ON position. XLR Connector pin-out - Pin 1: Ground,
Pin 2: Hot (+), Pin 3: Cold (-)
Line Level Input - Stereo Input Channels
The MDR6’s stereo channels have a stereo LINE input with the Left Input located in the center of the Combie con-
nector and a separate 1/4-inch connector for the Right Input. You can connect the outputs from stereo devices
such as synthesizers, drum machines, effects processors or any stereo line-level signal. The LINE inputs have a nomi
-
nal operating level of -40dB through - 10dB. TRS phone jacks Connector pin-out - Sleeve: Ground, Tip: Hot (+), Ring:
Cold (-)
Microphone Input - Stereo Input Channels
The MDR6’s stereo channels have a utility MIC input located on the Combie connector. The utility MIC inputs have a
nominal operating level of –50dB through -20dB. The MIC inputs also feature +48V phantom power, allowing you
to use condenser microphones. The Phantom Power switch located on the MDR6’s rear panel enables phantom
power on all the microphone inputs when set to the ON position. XLR Connector pin-out - Pin 1: Ground, Pin 2: Hot
(+), Pin 3: Cold (-)































   

MDR6 Input and Output Connections
CHANNEL 1–6 MIC and LINE INPUTS
The MDR6’s six input channels each have a "Combie" (combination XLR & 1/4-inch) connector with a LINE level, Hi-Z
(High Impedance) input and a MIC level, Low-Z (Low Impedance) input. By using the GAIN control on channels 1 +
2 you can connect a variety of signal sources from microphones to line level devices such as synthesizers, and drum
machines. All the LINE and MIC inputs are balanced. The MIC inputs are compatible with microphones with output
impedances of 50~600 Ohms and the LINE inputs are compatible with line level devices of 600 Ohms.
NOTE: It is not possible to simultaneously use both the LINE and MIC inputs on the same channel (with the exception on
the stereo input channels). Use only one of the inputs for the appropriate source on each channel.
Following below is a detailed description of the MDR6’s input and output connectors.
1
1
3
3
4
4
5
6
2
7 89
2
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson MDR6 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson MDR6 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 15,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info