630067

Samson CR4 Manual

5
Zoom out
Zoom in
Previous page
1/40
Next page
Guided Tour - CRND Receiver
1: Antenna mounting - Connect the
supplied antenna to this mounting.
Third-party receiver antennas should
not
be substituted—use only the antenna
provided with the CRND. See the
“Setting Up and Using the Concert IV
System” section on page 6 for more about
antenna installation and positioning.
2: “TX ON” LED - Lights when carrier
signal of sufficient strength is being
received by the CRND.
3: Squelch control - This control determines the maximum range of the CRND before audio signal
dropout. It should normally be left at its factory setting. For more information, see the “Setting Up and
Using the Concert IV System” section on page 6 in this manual.
4: Peak LED - This LED lights when output signal from the CRND is at the onset of clipping (that is,
when it is on the verge of being distorted). If you see this light during operation, move the microphone
further away or lower the output level of your instrument or transmitter. For more information, see the
“Setting Up and Using the Concert IV System” section on page 6 in this manual.
5: Volume - This knob determines the level of the audio signal sent from the unbalanced output jack on
the rear panel.
6: Power LED - Lights whenever the CRND is powered on.
7: DC input - Connect the supplied AC
adapter here. WARNING: Do not substitute
any other kind of power adapter; doing so
can cause severe damage to the unit and
will void your warranty.
8: Unbalanced output - Use this
unbalanced high impedance (5K Ohm)
1/4" jack to connect the CRND to the
microphone input of your mixer. The jack is
wired as follows: tip hot, sleeve ground.
9: Rear-mount antenna knockout - The CRND antenna (normally mounted on the front panel) can
optionally be mounted on this area of the rear panel. Contact Samson or your local distributor for further
information.
Rack-mounting the CRND
As shown in the illustration below, one or two CRND receivers can be mounted in a single 19" rack space
with the use of an optional adapter available from Samson or your local distributor.
5
ENGLISH
min max
1
0
2
3
4
5
6
7
8
9
10
ANTENNA
VOLUME
SQUELCH
PEAK
TX ON
POWER
CONCERT
ND
SAMSON
VHF RECEIVER
Channel 16
2
1
3
4
5
6
UNBALANCED
OUTPUT
RECEIVER
SAMSON
MADE IN U.S.A.
ANTENNA
CAUTION USE 12 VDC
OUTPUT ADAPTER ONLY
PLUG LOCK
FOR AC
ADAPTER
DC INPUT 12V
1.2 W(100 mA)
-10 dBv 5 K Ω
+
-
7
8 9
m
in
m
a
x
1
0
2
3
4
5
6
7
8
9
1
0
ANTENN
A
VO
LUM
E
SQ
UE
LCH
PEA
K
TX O
N
PO
W
E
R
C
O
N
C
ER
T
lV
SAMSON
V
H
F
R
E
C
E
IV
E
R
Channel 16
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson CR4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson CR4 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info