629996

Samson C.control Manual

12
Zoom out
Zoom in
Previous page
1/76
Next page
ENGLISH
Setting-up the C•control
10
Speaker A
The Speaker A outputs are balanced, 1/4-inch, TRS (Tip/ Ring/ Sleeve) phone connectors which output a +4dB
line level signal. You can connect to an active studio monitor or power amplifier here.
IMPORTANT NOTE:
In order to maintain the best gain structure and signal to noise ratio, we highly recom-
mend that only balanced cables be used on the SPEAKER A outputs. For detailed balanced cable wiring dia-
grams, please see page 17 in this manual.
Speaker B
The Speaker B outputs are unbalanced, RCA connectors which output -10dB line level signal. You can connect
to an active studio monitor, multimedia speaker or power amplifier here.
Speaker C
The Speaker C outputs are unbalanced, RCA connectors,
which output -10dB line level signal. You can connect to
an active studio monitor, multimedia speaker or power
amplifier here.
External Cue Output
The External Cue outputs are balanced, 1/4-inch, TRS
(Tip/ Ring/ Sleeve) phone connectors which output a
+4dB line level signal. This output is used to connect the
signal from the Talkback microphone to your headphone
cue mix. Many good headphone amplifiers such as the Samson C cue 8 or Samson S phone provide an auxilia-
ry input so that you can mix in the signal from the talkback mic with the stereo cue mix from your mixing con-
sole. This convenient feature allows the engineer and/or producer to talk to the talent over the headphone
mix. There is more information on the Talkback feature in the section “Operating C control” following later in
this manual.
TALK REMOTE
The C control’s TALKBACK microphone can be turned on and off from an external switch connected to the
TALK REMOTE input. The 1/4-inch phone jack is wired, “normally-open”, so a switch that shorts the TALK
REMOTE jack’s TIP to its SLEEVE will turn the TALKBACK microphone on and off in a momentary action. This
will allow the producer to move freely about the studio while talking to the talent.
AC INLET
The AC Inlet is where the C control receives it power from the included 18-volt AC power supply. Be sure to
use only the Samson AC1800 when operating the C control.
.
POWER
AC IN
14 V
SAMSON
MADE IN CHINA
+
-
500mA
MIX IN
2TK
A2TK B2TK C2TK A2TK B2TK C
L
R
L
R
R
L
SPK AEXT CUE
TALK
REMOTE
SPK B
SPK
C
BALANCEDBALANCED
BALANCEDBALANCED
BALANCEDBALANCED BALANCED
INPUT
OUTPUT
8
9
10
11
12
13
891011
13
12
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson C.control at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson C.control in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 21,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info