769721
49
Zoom out
Zoom in
Previous page
1/58
Next page
49
6.3 Chimney and flue pipes
We guarantee the proper functioning of the appliance if the chimney draught is between 12 and 20 Pa. If the
chimney draught is too high, then a damper must be incorporated.
If there isn’t enough chimney draught, then the following measures can be considered:
Extending the chimney
Improving the insulation of the chimney (less cooling of the flue gases)
Increasing the supply of combustion air into the space in which the appliance is installed.
Improving the airtightness of the chimney
Many problems with inset fires are caused by badly working chimneys. Therefore some suggestions:
A round channel is preferred (minimum friction)
The diameter of the chimney may not be smaller at any point than that of the appliance
The mouth of the chimney should be unobstructed
The chimney should be as close as possible to vertical with as few curves as possible.
The chimney must not draw in extra air. Watch out for flue dampers and cleaning hatches in the cellar or
on the roof!
The chimney may not have too many connections - that reduces the upwards pressure. Consult your
chimney specialist!
Flue connections to different stoves and fireplaces may not be located opposite each other at the same
height, in order to prevent the chance that combustion gases will not be drawn out. Two flue connections
must be at separated vertically by at least 30 cm.
For the chimney opening, you will need to comply with your national legislation.
For details on chimneys we refer you to the relevant regulations with which the chimney needs to comply.
6.4 Fitting the frame
The 4-sided finishing frame is secured using 4 screws on the
top and bottom of the convection mantle.
The 3-sided frame finish is also fixed using 4 screws on the top
and bottom right and left corners.
After the frame is screwed into the convection mantle, the fire
door must be opened. The frame is then screwed tight using a
hex key.
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saey High Line 60 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saey High Line 60 S in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 2.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info