4 INSTALLATION
4.1 Packaging
The original packaging has been designed to protect the
machine during transport. We recommend keeping the
packaging for future transport.
4.2 Installation Instructions
Before installing the machine, read the following safety
instructions carefully:
• Placethemachineinasafeplace;
• Makesurechildrencannotplaywiththemachine;
• Donotplacethe machineonhotsurfacesornear open
ames.
The coee machine is now ready to be connected to the power
supply.
4.3 Machine Connection
Appliance voltage has been pre-set by the manufacturer.
Check that the power voltage matches the indications on the
identication plate located on the bottom of the appliance.
• CheckthattheON/OFFbutton(17)isnotpressedbefore
connecting the machine to the power supply.
• Thepowercordislocatedinsidethemachine.Followthe
instructions in section 4.4 to lift the water tank.
(Fig.3) - Place the power cord correctly, so that it does not
interfere with the water tank.
• Fit the plug into a wall socket with suitable power
voltage.
4.4 Water Tank
• (Fig.1) - Remove the cover from the water tank (4).
• - Lift the suction pipe and remove the water tank
(5); make sure not to damage the water suction pipe.
• (Fig.4) - Rinse the tank and ll it with fresh drinking water
taking care not to overll.
• (Fig.5) - Lift the suction pipe and t the tank back into its
housing.
• (Fig.6) - Correctly replace the water suction pipe into the
tank; and place the cover back onto the tank.
4.5 Priming the Water Circuit
Before starting up the machine, after a long inactivity and
when all the water has been dispensed, the machine’s water
circuit must be primed.
• (Fig.7) - Press the ON/OFF button (17).
• (Fig.8) - Place a container below the steam spout. Open
the hot water/steam knob (3) by turning it counter-
clockwise and press the brew button (15).
• Wait until a steadyjetofwater ows out of the steam
spout (Pannarello).
• Pushthebutton(15)andclosethehotwater/steamknob
(3) by turning it clockwise.
4.6 Water Circuit Rinsing
This simple operation ensures an optimum brewing and must
be performed:
- at rst start-up;
- if the machine is to remain inactive for a long time.
• (Fig.8) - Place a container under the steam wand
(Pannarello). Open the knob (3) by turning it counter-
clockwise and press the brew button (15).
• Dispensehalfthewatertankcontentfromthesteam/hot
water wand. To end the operation, press again the brew
button (15) and close the knob (3) by turning it clockwise.
• - Insert the Portalter into the brew unit
from the bottom (7) and turn it from left to right until it
locks into place.
• PlaceasuitablecontainerunderthePortalter.
• Pressthebrewbutton(15)anddispenseallthewaterleft
in the water tank. Once the tank is empty, stop dispensing
by pressing the brew button again (15).
• Fill the tank again and wait until the "machine ready"
brew button (15) turns on.