Manual Sabo R43 (page 47 of 100) (English, German, Dutch, French, Italian, Spanish)

661056

Zoom out

Zoom in

1/100

Pos: 22.2 /Innenteil/Störungsursachen und deren Beseitigung/1 STÖRUNGSURSACHEN UND DEREN BESEITIGUNG @ 0\mod_1115373523343_1521.docx @ 1904 @ 1 @ 1

18 TROUBLESHOOTING

Pos: 22.3.1 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/1 Tabellenkopf @ 0\mod_1115374760156_1521.docx @ 1884 @ @ 1

Fault Possible cause Remedy

Pos: 22.3.2 /Innenteil/Störungsursachen und deren Beseitigung/Störu ngstabellenelemente/Motor springt nicht an E-Start 43-COMPACT (fixed speed) Quantum+675EXi @ 44\mod_1469430359850_1521.docx @ 506084 @ @ 1

Engine does not start

Control handle not

turned down.

Press the control handle onto

the upper part of the bar D .

Fuel tank empty. Fill up with clean and fresh

fuel.

Spark plug connector

loose.

Push plug connector in place

or have it checked by an

authorised workshop.

Spark plug defective or

soiled or electrodes worn

out.

Replace or clean spark plug,

set electrode distance Y .

0.5 mm

(for model SA1462, SA1461,

SA1406)

0.7 - 0.8 mm

(for model SA1741).

Too much petrol feed to

engine (spark plug wet).

Have it checked by an

authorised workshop.

Air filter soiled. Clean or replace the air filter

insert W .

Battery not charged (only

for electro-start).

Charge battery W1 , X1 .

Start-up takes longer

than 5 seconds or is

repeated too often

(only for electro-start).

If you experience start

difficulties, contrary to

expectations, the battery

must also be charged in

between.

Connection cable

between the ignition key,

battery and engine is

loose or without contact

(only for electro-start).

Connect the battery

connector with the mating

connector on the harness U1

or check it or have it checked

by an authorised workshop.

Pos: 22.3.3 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motorleistung lässt nach @ 33\mod_1408527299785_1521.docx @ 241497 @ @ 1

Engine power

decreasing

Air filter soiled. Clean or replace the air filter

insert W .

Spark plug clogged with

soot.

Have it checked by an

authorised workshop.

Fuel old or soiled Empty the petrol tank and fill

with fresh petrol.

Pos: 22.3.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motor läuft unregelmäßig @ 0\mod_1127909273145_1521.docx @ 1891 @ @ 1

Engine runs irregularly

Air filter dirty. Clean or replace air filter

insert W .

Spark plug contaminated

with soot.

Have it cleaned by an

authorized dealer.

Have it checked by an

authorized dealer.

Pos: 22.3.5 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Starke Erschütterungen (Vibrieren) @ 0\mod_1115377318234_1521.docx @ 1900 @ @ 1

Extreme vibration

Have it checked by an

authorized dealer

Pos: 22.3.6 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Schnitt unsauber, Rasen wird gelb, Benzin @ 0\mod_1115377468656_1521.docx @ 1898 @ @ 1

Unclean cut, lawn is

yellow

Blade blunt. Have it sharpened and

balanced by an authorized

dealer Q .

Cutting height too low. Adjust to higher cutting height

I .

Engine speed too low. Operate at max. rpm.

Mowing too fast. Adjust mowing speed.

Insufficient overlapping

of cuts when mowing.

Tall grass conditions may

dictate that more overlapping

of cuts is required.

Lawn becomes matted. A lawn scarifier can remedy

the problem considerably

Pos: 22.3.7 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Auswurf verstopft, Benzin, TurboSignal MUSTER @ 17\mod_1331728502002_1521.docx @ 134644 @ @ 1

Ejector blocked

TurboSignal ignored

J + K .

Empty the collecting bag L .

Engine speed too low. Have it checked by an

authorized dealer

Cutting height too low

with grass too high.

Set higher cutting height I .

Mowing speed too fast. Adapt mowing speed, switch

motor drive off if necessary.

Grass is damp. Allow the lawn to dry.

Pos: 22.3.8 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Gemulchte Gras sieht schlecht aus Heckauswurf @ 5\mod_1183467132357_1521.docx @ 35950 @ @ 1

Mulched grass

appearance is poor:

clumps, excessive

clippings, rough cut.

Blade blunt. Have it sharpened and

balanced by an authorized

dealer.

Mulching rule not

followed (cut max. 1/3 of

the grass height; the

height of the grass to be

cut must be lower than

10 cm)

Adjust to higher cutting height

I .

Convert mower to rear

discharge U2 + S1 and

mow grass first with higher

cutting setting.

Travel speed too fast. Adjust travel speed.

Grass build-up under

deck.

Adjust to higher cutting height

I .

Insufficient overlapping

of cuts when mowing.

Tall grass conditions may

dictate that more overlapping

of cuts is required

Grass not dry. Adjust to higher cutting height

I .

Let grass dry.

Pos: 22.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungsursachen und deren Beseitigung Text Benzin @ 0\mod_1115378183390_152 1.docx @ 1905 @ @ 1

In case of faults and defects which have not been listed here, please contact the

nearest authorized dealer.

Repairs which require specialized knowledge should only be performed by a qualified

expert. Your authorized dealer will naturally also be glad to help if you do not wish to

perform the maintenance work described here yourself.

Pos: 23.1 /---------- 1 Leerzeile ---------- @ 0\mod_1114611787140_1521.docx @ 2070 @ @ 1

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sabo R43 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 3,06 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sabo R43 Manual

Product: