643888

Russell Hobbs 20330-56 Manual

109
Zoom out
Zoom in
Previous page
1/116
Next page
109
[
5 You may now carry the whole appliance by gripping the handle of the iron with one hand,
and putting the other hand underneath the base unit for support.
C WATER
6 Use tap-water – the anti-scale cartridge will soften the water.
7 If the-scale cartridge needs replacing, and you don’t have a replacement, use distilled water
while you’re waiting for the replacement.
9 Don’t add anything to the water – you’ll damage the iron.
V FILLING
10 Switch off (2), and unplug before filling.
the easy way
11 With the reservoir in place, pour water into the funnel in the rear of the base unit.
12 The bottom of the funnel feeds directly into the reservoir.
13 Fill the reservoir to the x mark.
14 Initialize the iron.
the other way
15 Reach under the end of the reservoir, raise the reservoir release, and slide the reservoir out of
the base unit.
16 Pour water into the hole in the top of the reservoir.
17 Fill the reservoir to the x mark.
18 Slide the reservoir into the base unit till the catch clicks into place.
19 Initialize the iron.
C SWITCH ON
20 Sit the iron on the base unit.
21 Check that the clamps are in the release position (press U).
22 Lift the iron off the base unit, unwind the steam pipe from its niche above the reservoir and
cable storage, then set the iron back on the base unit.
23 Open the cable storage ((), pull out the plug and all the cable, thread the cable through
the adjacent gap, and close the cable storage.
24 Put the plug into the power socket.
•The 2 button will blink red.
25 Press the 2 button to switch the appliance on.
•The 2 button will stop blinking and glow green.
•The r button will glow, to show that the boiler is operating.
•The S button will blink, to show that steam is being generated.
•The # light will glow
26 Press the S button to choose the steam level you want.
•The steam level lights are: S = low, ~ = medium, # = high.
27 When the S button glows steadily, the boiler is ready to make steam.
28 It’ll then cycle on and off as the boiler works to maintain the temperature.
29 If the temperature control on the iron is set above room temperature, the thermostat light on
the iron will glow, to show that the soleplate is heating up.
instructions
diagrams
1 latch
~ steam button
2 handle
3 temperature control
4 thermostat light
5 soleplate
6 steam pipe
7 funnel
8 clamps
9 boiler access knob
10 cable
11 cable storage
12 base unit
13 reservoir
14 reservoir lock
15 anti-scale cartridge
16 compartment
17 door
18 press to initialize
… 109 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Russell Hobbs 20330-56 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Russell Hobbs 20330-56 in the language / languages: All languages as an attachment in your email.

The manual is 3,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info